Cart 2 india

Specification
Brand : 育良精機(Ikura)
BulletPoint1 : Hole Diameter (Φ): 1.0 inch (25.0 mm)
BulletPoint2 : Depth: 6 - 35 t.)
BulletPoint3 : Center Pin: CP-35S1(t6 - 21)
BulletPoint4 : CP-35D1(t12-35)
BulletPoint5 : Compatible models: ISK-LB30Li
Color : 22x35mm
ExternallyAssignedProductIdentifier : 4992873372307
ItemName : Ikura Seiki ISK-3QC250 35QC Quick Cutter (Carbide)
ItemPackageDimensions_Height : 90 millimeters
ItemPackageDimensions_Length : 150 millimeters
ItemPackageDimensions_Width : 100 millimeters
ItemPackageQuantity : 1
ItemTypeKeyword : annular-cutters
Manufacturer : 育良精機(Ikura)
ModelNumber : ISK-3QC250
NumberOfItems : 1
NumberOfPieces : 1
PackageLevel : unit
PartNumber : ISK-3QC250
ProductDescription : Item Type: Annular Cutter Arbor
Model: MT3
Color: Silver
Material: Steel
Inner Diameter: Approx. 19.05mm / 0.8in
Total Length: Approx. 175mm / 6.9in
External Cooling Fixture: External cooling is required when drilling (external cooling nozzle or pot can be used for watering, equipment without a kettle is preferred)
Application: Magnetic drill, radial drill, bench drill, lathe, vertical drill drilling equipment, etc.

Package List：
1 x Annular Cutter Arbor
1 x Wrench

Note:
1. Before starting to drill, make sure that the tool has been completely installed in place, and there is no looseness or unclamping situation.
2. When using a magnetic drill to drill, it must be ensured that there is no iron filings under the magnetic block of the drill, the adsorption surface is flat, and the machine has no swing or incomplete adsorption.
3. The whole process from the beginning of the drilling to the completion of the drilling should be kept cool enough without interruption. Brief cooling can easily cause tool chipping.
4. At the beginning of drilling, the tool should be fed slowly and smoothly, and the feed speed can be increased after cutting into 1~2MM. When exiting the tool, slow down the feed speed appropriately, and keep the feed evenly during the middle cutting process.
5. The reasonable linear speed of the cutting should be more than 40 meters per minute when drilling hard alloy steel plates, and the minimum should not be as low as 30 meters. At the same time, cemented carbide is a high‑hardness material. The blade should be prevented from bumping during storage and retrieving, and impact should be prevented during use.


ProductSiteLaunchDate : 2025-05-20T15:30:32.782Z
Size : One Size
SupplierDeclaredDgHzRegulation : unknown
UnitCount : 1
UnspscCode : 27112700