Cart 2 india

Specification
AgeRangeDescription : adult
Brand : easytooly
BulletPoint1 : 1PC of LOK to MNPT Tube Fitting Connector
BulletPoint2 : Material: 316 Stainless Steel
BulletPoint3 : Straight fittings are machined from bar stock and shaped fittings from forgings.
BulletPoint4 : Seal Material:Silicon
Color : One Color
Department : Unisex Adult
ExternallyAssignedProductIdentifier : 8383787713083
ItemName : 1PC SS316L Male Bulkhead Union 1/8 1/4 3/8 1/2 inch LOK to MNPT Tube Fitting Connector 3000psi Stainless Steel replace(0.25 inch)
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : compression-bulkhead-fittings
Manufacturer : easytooly
ModelName : easytooly
ModelNumber : easytooly
NumberOfBoxes : 1
NumberOfItems : 1
NumberOfPieces : 1
PartNumber : easytooly
ProductDescription : 1PC SS316L Male Bulkhead Union 1/8 1/4 3/8 1/2 inch LOK to MNPT Tube Fitting Connector 3000psi Stainless Steel replace

Features
- Provide a reliable, leak proof seal under severe conditions such as temperature cycling, vibration and pulsation.
- Contribute to productivity improvement because of machined surfaces on the inner finishing.
- Assembled easily without the requirement of any special tools.
- Excellent finish level to allow smooth flow transition.
Material: 316 Stainless Steel
Straight fittings are machined from bar stock and shaped fittings from forgings.

Installation Instruction
1. Firmly insert the tubing until it bottoms in the fitting body.
2. Finger tighten the nut.
3. Mark the nut at the 6 o'clock position, with pencil or scribe.
4. Hold the body with a backup wrench, or vice, then tighten nut.
5. 1-1/4 turns to the 9 o'clock position.
6. The above applies to all fittings from 1/4"to 1"(6mm to 25mm).
7. Fittings from 1/16"to 3/16"(3mm to 4mm), only 3/4 turn is required.

Package Including: 1 piece tube fitting.

Application
For inert gas, reactive, flammable, oxidizing and gas mixtures, Purity max. 6.0.
Tube Fittings are appropriate for Gas Systems, but the implementation of certain standards mentioned below should be adhered to just as in other systems.
1. Tubing hardness must be less than that of the ferrules.
2. Tubing should be far away of finishing imperfections, defects and round in shape.
3. Tubing ends must be cut squarely and perpendicular to the center-line of the tubing. After the tubing is cut it must be deburred on both the inside and outside with a fully sharpened deburring tool.
ProductSiteLaunchDate : 2024-12-03T12:12:41.656Z
Size : 0.25 Inch
UnitCount : 1
UnspscCode : 40141700