Cart 2 india

Specification
Brand : SASKATE
BulletPoint1 : The measurement circuit is isolated from the incoming signal. Hall‑type current conversion, which can withstand 30 times the nominal input, prevents instantaneous high current access and burns out the internal components of the sensor, which is very
BulletPoint2 : Isolate the detection signal and the output signal, effectively filter the noise in the signal, greatly improve the signal-to-noise ratio and signal stability of the product, and effectively enhance the product's anti-interference ability
BulletPoint3 : The primary and secondary sides of the hole current transmitter are highly insulated and isolated, featuring , small size, low power consumption, wide frequency response, and anti-interference characteristics
BulletPoint4 : Perforated input, no insertion loss, fixed with standard rail and flat screws, easy to install
BulletPoint5 : Especially suitable for generators, motors, intelligent low-voltage power distribution cabinets, air conditioners, fans, street lamps, power grid monitoring, motor signal monitoring, railway system signal monitoring industries and other load current intelligent monitoring systems
Color : #311
ExternallyAssignedProductIdentifier : 6276123787874
ItemName : AC0 5A Current Transmitter, DC4 20mA Output, Isolated Signal for Power Distribution Control. Hall type Sensor, Anti Interference Design, Easy Installation
ItemPackageDimensions_Height : 3 centimeters
ItemPackageDimensions_Length : 13 centimeters
ItemPackageDimensions_Width : 8 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : current-transducers
Manufacturer : SASKATE
ModelName : Saskateowmz2qkbhx
ModelNumber : SASKATEowmz2qkbhx
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : SASKATEowmz2qkbhx
ProductDescription : Specification:
Item Type: AC Current Transmitter
Material: ABS
Power Supply: DC24V
Installation Method: Standard rail + flat screw fixation
Product Use: Used to measure AC current, especially for power frequency 50Hz sine AC current
Rated Current: AC0-5A
Rated Output: DC4-20mA
Load Capacity: Voltage Output: 5mA; Current Output: 6V
Accuracy: 0.5%
Overload Capacity: 30 Times the nominal input
Isolation withstand Voltage: 3KV/50Hz, 1Min
Offset Voltage: ≤10mV
Temperature Drift: ≤500PPM/℃
Linearity: 0.1%
Frequency Bandwidth: 20-5KHz
Current Consumption:

PackageList:
1 x AC Current Transmitter

Notice:
Please do not use 250ohm or 500ohm to connect 4‑20mA output version of the transmitter to get 0‑5V or 0‑10V, this is a completely wrong method, you cannot get 0‑5V or 0‑10V signal, and it will make transmit becomes overheated or damaged.
ProductSiteLaunchDate : 2025-05-07T10:08:17.788Z
Size : One Size
UnitCount : 1