Cart 2 india

Specification
Brand : Generic
BulletPoint1 : High Strength Plastic & Detailed Etching
BulletPoint2 : Reusable Hundreds of Times
BulletPoint3 : Smooth Texture To Create A Beautiful Paver
BulletPoint4 : Indoor/outdoor use
Color : Jade
ExternallyAssignedProductIdentifier1 : 0632793182733
ExternallyAssignedProductIdentifier2 : 632793182733
ExternallyAssignedProductIdentifier3 : 00855420008170
ItemName : Plastic Mold Form for Beautiful Concrete Paver Stones for Patio and Garden (New)
ItemPackageDimensions_Height : 34.1122 centimeters
ItemPackageDimensions_Length : 11.9126 centimeters
ItemPackageDimensions_Width : 33.909 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : stepping-stones
Manufacturer : Elite Molds
Material : Plastic
ModelName : Décor Pebbles
ModelNumber : PJS-0510J
NumberOfBoxes : 1
PackageLevel : unit
PartNumber : PJS-0510J
PowerSourceType : Manual
ProductDescription : These are high quality plastic molds for creating beautiful concrete paver stones. They can be made with little to no equipment! Great for a D-I-Y project or to save costs on pavers by making them yourself, or even producing and selling/installing the pavers! This sale comes with two pieces: large mold and small mold Measurements: Paver produced will be 11.5" L x 11.5" W x 1.75" H (large) & 8.5" L 8.5" W x 1.75" H (small) What to use pavers for: Patio Walkway Stepping stones Driveway Pavement extensions Outdoor tile How to Make Pavers: 1) Start by having a clean mold ready and concrete mix ready 2) Mix concrete with water until the mix is ready to be used *You can tell when the mix is ready when it has been thoroughly mixed and when you squeeze it, it still has a structural form and doesn't feel thin and soupy due to too much water 3) Insert mixed concrete into molds 4) Shake or vibrate the concrete mix so it settles into the mold and air pockets begin to be released. *The more vibration, the better, especially if done by hand. Air pockets should start being released from the concrete, this allows the concrete to flow into the molds' etching and corners. This also allows the texture to be very smooth as the cement settles to the face of the mold. 5) When finished vibrating, set paver aside to cure for 24-48 hours 6) Once concrete is hardened and properly cured, release the concrete paver from the mold. * Releasing the paver from the mold can be done by snapping the sides of the paver off the mold, then lightly tapping the paver mold upside down on each side until the paver can slide out freely from the mold. Don't force the paver out, it can chip or damage the concrete as it is still fragile. 7) Allow released paver to dry completely and cure. It is recommended to wait 2-4 days before using the paver so that most of the concrete can cure and develop its strength 8) Your paver is ready for use! *Clean mold with Muriatic Acid
SupplierDeclaredDgHzRegulation : not_applicable
UnspscCode : 56101600