Cart 2 india

Specification
Brand : Whataval
BulletPoint1 : 【ORIGINAL QUALITY MATERIAL】The Braided Desoldering Wick is made of 100% copper wires, fast heat conduction, once the desoldering wick and the solder has been heated, the solder braid can quickly absorbed molten solder and left a clean working area
BulletPoint2 : 【EASY TO USE】The desoldering wicks can provide an easier way to correct mistakes on small PCB boards and will not make any damage to the board, clean small components, suitable for re-soldering and desoldering, can improve the capillary effect and the redundant solder absorbing ability, increasing your efficiency
BulletPoint3 : 【GREAT SIZE】3.0mm*20m is the most popular size of the big size desoldering wick, use at ease. No fluorine, low residue, suitable for a variety of PCB circuit boards
BulletPoint4 : 【WIDELY USED】The braided solder wicks are suitable for labs, home and industry welding work, practical tools to remove solder and correct errors on small PCB boards, bringing lots of convenience for your work
BulletPoint5 : 【PROFESSIONAL TOOL】It is not an easy job for someone who has no technical skills with desoldering or soldering boards or ic, so only purchase this item if you know how to install it. Highly recommend professional installation
ExternallyAssignedProductIdentifier : 7467209294099
ExternallyAssignedProductIdentifier1 : 0662211259334
ExternallyAssignedProductIdentifier2 : 662211259334
IncludedComponents : desoldering wick
ItemName : WHATAVAL Desoldering Wick Braid CP-30B 3.0mm Width 20m Length Desolder Solder Wick Wire Roll PCB Motherboard Mobile Phone Repair Remover Tool
ItemPackageDimensions_Height : 2 centimeters
ItemPackageDimensions_Length : 5 centimeters
ItemPackageDimensions_Width : 5 centimeters
ItemTypeKeyword : desoldering-wicks
Manufacturer : whataval
Material : copper
ModelName : desoldering wick
ModelNumber : 198709
PartNumber : LBECe4i9wu6p5t-13
PowerSourceType : hand_powered
ProductDescription :
WHATAVAL

How To Use

1.Put an appropriate length of the suction wire on the solder joint that needs to be cleaned, and then use a soldering iron to heat it.
After the solder joint melts, the suction wire will be sucked away from the solder joint.

2.After sucking away the tin on the solder joints, please remove the soldering iron and the suction wire at the same time.

3.Use scissors and pliers tools to be used,The suction wire can be cut off.

Type: CP-30B 3.0mm*20m ( ORIGINAL )
ProductSiteLaunchDate : 2022-12-13T04:07:29.103Z
Size : CP-2515
Style : Cp-3015
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 23271800