Cart 2 india

Specification
Brand : WOIWO
BulletPoint : Security 5 ft. 3 mm BGA Desoldering Wire Braid Solder Remover Wick Soldering Accessory Metal Color Tin TU-3015
BulletPoint1 : Provides safe, low cost disassembly methods for printed circuit boards and assemblies.
BulletPoint2 : Bulk spring plunger can remove solder quickly in one action.
BulletPoint3 : The tool is easy to remove, quick to clean, and the tip and "O" ring can be replaced.
BulletPoint4 : Each use, the plunger pin will automatically remove the solder.
BulletPoint5 : Material: aluminum frame + plastic + stainless steel. Color: silvery blue. Size: 18.5cm. Weight: 40 g
ExternallyAssignedProductIdentifier1 : 0723849047844
ExternallyAssignedProductIdentifier2 : 723849047844
HeatingElementType : Ceramic
ItemLength : 7.28 inches
ItemName : WOIWO 1PCS Electric Soldering Lron Half Aluminum Tin Absorbers Lron Rod Tin Absorbers Electronic Tool Set Fittings
ItemPackageDimensions_Height : 0.1 inches
ItemPackageDimensions_Length : 0.3 inches
ItemPackageDimensions_Width : 0.2 inches
ItemTypeKeyword : desoldering-wicks
Manufacturer : WOIWO
Material : silver
PartNumber : HDL1402
PowerSourceType : Corded Electric
ProductDescription : Material: aluminum frame + plastic + stainless steel
Color: silvery blue
Size: 18.5 cm
Weight: 40 g
Usage of tin suction device:
1. First, press down the piston of the tin suction device until it is stuck.
2. Heat the solder joint with an electric iron until it melts.
3. While removing the electric soldering iron, quickly attach the solder tip to the solder joint and press the button of the soldering pen.
4. Once suction is not clean, the operation can be repeated for many times.
Tips for using tin suction device:
(1) Make sure that the piston of the tin suction device is sealed well. Before energizing, plug the hole in the tin suction head with your finger and press the button. If the piston is not easy to pop into place, the seal is good.
(2) The pore size of the tin suction head has different sizes, so it is necessary to choose the appropriate specifications for use.
(3) After the tin suction head is used, it should be replaced in good time.
(4) Dip in a bit of rosin each time before touching the solder joint to improve the fluidity of the solder.
(5) It will take a little longer time for the head to contact the solder joint. When the solder is melted, take the solder pin as the center, draw a circle in a clockwise direction with your hand outward, and then press the button of the tin suction device
Note:
1. There may be some color difference due to the light and the monitor, please refer to the actual situation.
2. Because the size is measured manually, there will be some error, please understand!
ProductSiteLaunchDate : 2020-12-10T08:05:38.451Z
Style : Pencil
SupplierDeclaredDgHzRegulation : not_applicable
UnspscCode : 23271800