Cart 2 india

Specification
Brand : OQRSQOGV
BulletPoint1 : [PORTABLE DESIGN]: This industrial grade pneumatic grinder is small, light, and easy to operate with low vibration and ergonomic grip.
BulletPoint2 : [ MATERIAL]: Made of wear-resistant zinc alloy with a red protective cover for safety and reliability.
BulletPoint3 : [HIGH EFFICIENCY]: With a 3in grinding disc and a speed of 10000rpm, this air die grinder greatly improves grinding efficiency.
BulletPoint4 : [STANDARD INLET]: Equipped with a 1/4in air inlet and standard connector for easy installation and use.
BulletPoint5 : [APPLICABLE SCENES]: for grinding focal areas, removing solder joints, spots on metal products, and deburring wood.
ExternallyAssignedProductIdentifier : 8580887150224
IncludedComponents : No
ItemName : 3in Disc Industrial Air Die Grinder 90° Right Angle Pneumatic Portable Grinder with Zinc Alloy Material
ItemPackageDimensions_Height : 6 centimeters
ItemPackageDimensions_Length : 20 centimeters
ItemPackageDimensions_Width : 10 centimeters
ItemTypeKeyword : power-die-grinders
Manufacturer : OQRSQOGV
ModelName : OQRSQOGVpi6urgf9bs
ModelNumber : OQRSQOGVpi6urgf9bs
NumberOfBoxes : 1
PartNumber : OQRSQOGVpi6urgf9bs
PowerSourceType : ac/dc
ProductDescription : [PORTABLE DESIGN]: This industrial grade pneumatic grinder is small, light, and easy to operate with low vibration and ergonomic grip.
[ MATERIAL]: Made of wear-resistant zinc alloy with a red protective cover for safety and reliability.
[HIGH EFFICIENCY]: With a 3in grinding disc and a speed of 10000rpm, this air die grinder greatly improves grinding efficiency.
[STANDARD INLET]: Equipped with a 1/4in air inlet and standard connector for easy installation and use.
[APPLICABLE SCENES]: for grinding focal areas, removing solder joints, spots on metal products, and deburring wood.

Spec:
Item Type: Air Die Grinder
Model: YDE-8982B
Disc Size: 3in (75mm)
No Load Speed: 10000rpm
Air Pressure: 90psi (6.3kg/cm²)
Air Consumption: 4.0cfm
Air Inlet: 1/4in


Package List：
1 x Air Die Grinder
1 x Sanding Pad
1 x Wrench
1 x Intake Port

Note：
Suggestion:
1. Before and after use every day, please inject 2‑3CC of #60 pneumatic lubricating oil (sewing machine oil) from the air inlet
2. Let the machine idle for a few seconds after filling with oil
3. Generally, the air source compressed by the traditional air compressor contains water, and the lubricating oil in the air compressor brought out by the air compressor piston. If the oil water separator is not used, the water and oil enter the pneumatic tool with the air, which will cause wind If the blade is stuck, once the tool is started, the blade will not be thrown away, and it may not even be able to start. If it can be started, the torsion will be insufficient. Be sure to pay attention to refueling regularly to keep the tool at normal torsion.




ProductSiteLaunchDate : 2024-10-21T17:53:30.366Z
UnitCount : 1
UnspscCode : 27112700