Cart 2 india

Specification
AgeRangeDescription : adult
Brand : LJIA
BulletPoint1 : This item is a pressure water flow for power, pressure loss is small, without the need for any other power facility, water power the dozer for engine, drive the piston and connecting rod dosing device, the liquid additive direct inhalation and dissolved in water.
BulletPoint2 : This device motion in acylinder, the pressure to go out at the same time, the device will be installed at the bottom of the additive in the container through the catheter into the flow in uniform. Moving up and down repeatedly, so as to achieve the additive in a homogeneously continuously added to the water flow effect.
BulletPoint3 : 3. Powerful rotor, can effectively reduce water resistance.
BulletPoint4 : Control- More Easy to
BulletPoint5 : Manual Mode Auto ModeTime setting/Volume setting)
BulletPoint6 : High Performance Stepper Motor
Color : One Color
ExternallyAssignedProductIdentifier : 7505551702906
ItemName : Fertilizer Injector Dispenser Proportioner 12-3000L/h 0.2%-2% 4C-30C Auto Dosing Tools Dosing Device Controllable Dosing Devic with High Efficiency
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : science-lab-dosing-pumps
Manufacturer : LJIA
Material : Metal
ModelName : LJIA
ModelNumber : LJIA
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : LJIA
ProductDescription : The proportional pump can adjust the proportion of the additive in the injected water flow according to the actual situation, so that the additive is evenly added, the specific method is as follows:
1- Loosen the screw and remove the U-shaped adjustment lock from the upper part of the proportional pump.
2- Preset the ratio of liquid additive to water according to the ratio of the water scale on the proportional pump:
Counterclockwise adjustment is to increase the specific gravity of the liquid additive.
Clockwise adjustment is to reduce the specific gravity of the liquid additive.
The percentage on the proportional pump is calculated as the final water output of the proportional pump is 100.
3- Turn the adjuster until the U-shaped adjustment so that the upper hole is inserted into the notch of the proportional pump.
4- Press the U-shaped adjustment lock into the notch of the proportional pump until it is fastened to each other.
Specification:
Model: P2502
Proportion range: 0.2% - 2%
Flow range: 20-2500 liters / hour
Water flow temperature: 4 degrees -30 degrees
Working water pressure: 0.2-6 kg
Inlet and outlet diameter: 32mm/25mm Standard installation
Package List:
1 x Proportional Pump
1 x Bag of Round Gaskets (4Pcs)
1 x Buckle
1 x Capillary Tube (With Filter)
1 x Wrench
Notes:
1.Make sure that the container holding the liquid additive is not empty when using the automatic proportional pump!
2.bleed valve: At the beginning of starting the proportional pump, the bleed valve should be pressed down for a few seconds to discharge the existing air inside. There will be a little water flowing out in the process.Immediately after the air is released, close the bleed valve.
3.During installation and use, it is necessary to install filter equipment at the inlet of the proportional pump.
4.If there is an increase in working resistance during use, add lubricant to the piston
ProductSiteLaunchDate : 2024-05-12T04:00:23.831Z
Size : One Size
Style : G10 6V
UnitCount : 1
UnspscCode : 48101700