Cart 2 india

Specification
Brand : MBHALBY
BulletPoint1 : Model Number : Diamond Grinding Head
BulletPoint2 : Type : Abrasive Block
BulletPoint3 : DIY Supplies : Metalworking
BulletPoint4 : Length : 42mm
BulletPoint5 : Diameter : 1.0-4.0mm
Color : 1200 Grit
ExternallyAssignedProductIdentifier : 7018950817053
ItemName : 10pcs 2.35mm Shank Emery Polishing Diamond Grinding Head Mounted Points Jade Carving Burrs H Needle for Rotary Tools(1200 Grit,1.0mm)
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : abrasive-dressing-tools
Manufacturer : MBHALBY
Material : Metal
ModelName : MBHALBY
ModelNumber : MBHALBY
NumberOfItems : 1
NumberOfPieces : 1
PartNumber : MBHALBY
ProductDescription : The vibration polishing process:
After the carving, the 600 mesh tool is repaired.All over,it is necessary to have a high speed of 30,000 rpm or more. 1200 mesh tool repair. At the bottom of the groove, it is necessary to have a low speed of 2000 to 3000 thousand revolutions.

When using a diamond tool, please note the following:
1. When you install the new tool, you must try to test whether the tool is beating. If you jump, you can't work directly. You can adjust it to not use it. Otherwise the tool will wear out quickly and the
things carved out will not be very smooth. Adjustment method: Use a small wrench to change the high-speed tool holder until the tool is smooth. The electronic machine is strictly prohibited from tapping. The adjustment method is to loosen the chuck, turn the tool at an angle or extend and retract it.
2. It must be cooled by water (similar to the drip device in the hospital). For example, the diamond on the tool head will be graphitized due to overheating, which will quickly wear out and scrap.
3. When drilling, try to avoid shaking, because the shaking will cause partial damage to the tool and
accelerate the damage of the entire tool.
4. The speed is as high as possible. The line speed is generally required to be no less than 10-20 meters per second.
5. Light pressure feed, diamond tool is to grind to process the workpiece, excessive force, the grinding powder is not easy to eliminate, the tool is also easy to damage.
ProductSiteLaunchDate : 2024-10-28T08:47:49.981Z
Size : 1.0mm
UnitCount : 1
UnspscCode : 31191600