Cart 2 india

Specification
Brand : CONFAST
BulletPoint1 : POSITIVE DRIVE-Use a hammer to drive the nail to expand the anchor
BulletPoint2 : YELLOW ZINC PLATING-Helps prevent rusting in dry environments
BulletPoint3 : CAN SET EMBEDMENT DEPTH-Affords uniformity and consistent look after the anchors are set
BulletPoint4 : FOR CONCRETE ONLY-Provides consistent holding values
BulletPoint5 : NUTS AND WASHERS INCLUDED-Ready to install; simple and fast
Color : Yellow
CompatibleGrooveDiameter : 0.75 inches
ExternallyAssignedProductIdentifier1 : 662520027204
ExternallyAssignedProductIdentifier2 : 0662520027204
ExternallyAssignedProductIdentifier3 : 00662520027204
FinishType : Yellow Zinc
GradeRating : industrial
ItemName : CONFAST 3/4" x 5" Strike Anchor (20 per Box)
ItemPackageDimensions_Height : 3.5 inches
ItemPackageDimensions_Length : 9.5 inches
ItemPackageDimensions_Width : 5.5 inches
ItemPackageQuantity : 1
ItemShape : Block
ItemTypeKeyword : drive-anchors
Manufacturer : CONFAST
Material : Carbon Steel Yellow Zinc
Material1 : Carbon Steel Zinc Plated
Material2 : Carbon Steel Zinc Plated
Material3 : Carbon Steel Zinc Plated
Material4 : Carbon Steel Zinc Plated
Material5 : Carbon Steel Zinc Plated
MaximumShearStrength : 10125
MeasurementSystem : inch
ModelNumber : HS-1607
NumberOfItems : 20
NumberOfPieces : 20
PartNumber : SA345
ProductDescription : Applications
The anchor is made from Carbon Steel, and is Yellow Zinc. This anchor is designed for use in Concrete only, and should never be used in block or brick base material.

Environment
The anchor is designed for use in a Dry environment.

Hole Diameter/Bit Diameter
The anchor requires a 3/4" hole to be drilled in the base material (Concrete only). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Diameter of Anchor
The diameter of the anchor is 3/4".

Length Anchor
The length of the anchor is 5"
Minimum Embedment
The minimum anchor embedment into the concrete is 3". Therefore, the anchor must be installed so that a minimum of 3" of the anchor is embedded into the concrete.

Maximum Fixture Thickness
The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 1-1/4". This will ensure that the minimum embedment of 3" will be met.

Fixture Hole Diameter
The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 3/4" diameter anchor requires the hole in the fixture to be 7/8".

Spacing between Anchors
Each anchor must be spaced a minimum distance of 7-1/2" from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 3-3/4" from an unsupported edge of the concrete.
ProductSiteLaunchDate : 2017-06-13T03:57:34.701Z
Size : One Size
SpecificUsesForProduct : Brick
UnitCount : 1
UnspscCode : 31161500