Cart 2 india

Specification
Brand : Epoxy International
BulletPoint1 : Appearance: Black
BulletPoint2 : Cure Type: Heat cure or Room temperature
BulletPoint3 : Benefits: Continuity of conductivity High adhesion Wide operating temperature range
BulletPoint4 : Mix Ratio by weight: 100:12 / Resin:Hardener
BulletPoint5 : Substrates: Aluminum, copper, magnesium, steel, bronze, nickel, ceramic, glass, phenolic, G-10 epoxy glass boards
Color : Black
CompatibleMaterial1 : Metal
CompatibleMaterial2 : Glass
CompatibleMaterial3 : Carbon
CompatibleMaterial4 : Ceramic
ItemForm : Liquid
ItemName : Carbon-Bond 61LP Electrically Conductive, Carbon Filled, Long Pot Life Low Gassing
ItemPackageQuantity : 1
ItemTypeKeyword : conductive-adhesives
Manufacturer : Epoxy International
Material : Aluminum
NumberOfItems : 1
PartNumber : Carbon-Bond 61LP-100
ProductDescription : Mix Ratio by weight: 100:12 / Resin:Hardener Substrates: Aluminum, copper, magnesium, steel, bronze, nickel, ceramic, glass, phenolic, G-10 epoxy glass boards Operating Temperature: -50 to 170 C Typical Applications: Electronic bonding and sealing applications that require both fine electrical and mechanical properties. Shelf Life: 6 Months Compressive Strength, psi: 13,000 Specific Gravity, mixed: 1.35 g/cc Pot Life: 3 Hours 15 minutes: @ 100C 1 hour: @ 60C 24 hours: @ 25C Volume Resistivity: ohm cm: < 40 Tensile Strength, psi: 8,500 Shrinkage Linear: 0.003 in/in Hardness, Shore D: 85 Carbon-Bond 61LP Electrically Conductive, Carbon Filled, Long Pot Life Low Gassing is an epoxy adhesive and coating formulation based on conductive carbon.  This product's chemical formulation allows for micro-thin application and eliminted any air pockets or bubbling between thinly bonded substrates.Carbon-Bond 61LP Electrically Conductive, Carbon Filled, Long Pot Life Low Gassing is recommended for electronic bonding and sealing applications that require both fine electrical and mechanical properties.Carbon-Bond 61LP Electrically Conductive, Carbon Filled, Long Pot Life Low Gassing cures at room temperature or can be accelerated with mild heat to form a tenacious bond between similar and dissimilar substrates.For safe handling information on this product, consult the Material Safety Data Sheet, (MSDS).1) Carefully clean and dry all surfaces to be bonded.2) Apply ei-CARB 61 completely mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds; however, maintain contact until adhesive is completely cured.3) Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container be thoroughly mixed prior to use.4) Some ingredients in this formulation provided may crys
ProductSiteLaunchDate : 2016-03-28T14:21:49.129Z
UnspscCode : 31201600