Cart 2 india

Specification
Brand : CUNTO
BulletPoint1 : Small, lightweight and highly reliable weighing controllers
BulletPoint2 : Weigh controllers are devices that combine weighing and control functions in a single unit.
BulletPoint3 : The controller calculates and displays the weight of the material on the scale. The weight of the material on the scale is compared with the set value and if the set value is reached, the controller controls the actuator.
BulletPoint4 : Please allow a volume error of 1-3 mm due to manual measurement.
BulletPoint5 : Colours may vary slightly due to differences in monitors and conditions at the time of photographing.
Color : One Color
ExternallyAssignedProductIdentifier : 6418865608608
ItemName : Load Cell Display Pressure Weight Sensor Indicator Controller (Size : RS485)
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : electronic-indicators
Manufacturer : CUNTO
MeasurementAccuracy : 1
ModelNumber : CUNTO
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : CUNTO
ProductDescription : Function description: The 3 outputs of the meter can be set to be more than comparison or less than comparison.
The output is valid when the measured value is more than the upper limit minus hysteresis,
and the output is invalid when the measured value is less than the upper limit.
When the output is set to be less than the comparison, the output is valid when the measured value is less than the lower limit, and is invalid when the measured value is more than the lower limit plus hysteresis.
one second, can start the first and second group of relay closure and output effectively. When the measured value is more than the set value, the relay disconnect output is invalid until the next time, short connect the 3 and 4 terminals to output a valid bit for one cycle.
Peak holding mode (optional)
Function description: This mode of operation, by pressing the K3 key, can be switched to AXXXX (the peak measurement interface), which can maintain the last peak value, when the next measurement value is more than the ED-03 parameter (this is the peak threshold parameter) The last peak can be automatically overwritten to maintain this peak.
ProductSiteLaunchDate : 2024-01-30T07:56:24.727Z
Size : RS485
UnitCount : 1
UnspscCode : 41103313