Cart 2 india

Specification
Brand : GS Tooling
BulletPoint1 : Shank Type: Taper Shank
BulletPoint2 : Taper Size: CAT50
BulletPoint3 : Used for layout, set-up, checking heights, depths and setting angles
BulletPoint4 : Projection (mm): 80
BulletPoint5 : Nose Diameter (mm): 21
ExternallyAssignedProductIdentifier1 : 0752273562098
ExternallyAssignedProductIdentifier2 : 752273562098
ItemName : GS Tooling 541904 CAT50 8mm x 80mm Shrink Fit Holder with Coolant Ports
ItemPackageDimensions_Height : 9.25 inches
ItemPackageDimensions_Length : 4.44 inches
ItemPackageDimensions_Width : 4.44 inches
ItemPackageQuantity : 1
ItemTypeKeyword : end-mill-holders
Manufacturer : GS Tooling
NumberOfItems : 1
PartNumber : 541904
ProductDescription : Shank Type: Taper Shank
Taper Size: CAT50
Hole Diameter (mm): 8
Projection (mm): 80
Nose Diameter (mm): 21
Through Coolant: Yes
Unsurpassed Accuracy: Concentricity of ?0.0001" (3µm) with tool shrunk in holder. Coolant Ports: Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool. Max Gripping Torque: Tool is gripped 360º along the entire length of bore producing very high gripping torque, preventing chatter. Increased Production: Decrease down time - the total time elapsed to remove one cutting tool and insert another is less than 10 seconds. Balanced: GS follows the strictest balance standards. Our holders are pre-balanced G2.5 up to 30,000rpm Extended Holder Life: With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder. Chip load distributed evenly along cutting edge of tool which results in longer tool life Short projections are possible because no mechanical clamping devices are used. This results in greater rigidity and resistance to bending. Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market
ProductSiteLaunchDate : 2023-06-20T14:03:01.172Z
UnitCount : 1
UnspscCode : 27112803