Cart 2 india

Specification
Brand : FANRTE
BulletPoint1 : The ORIGINAL pole mount adapter bushing! Easily allows the use of a Harbor Freight (p/n 64342, 64344) and Camco(ASIN:B00192JG9O) 20' telecoping Flagpole for mounting a v3 rectangular/square Starlink dish.
BulletPoint2 : Bushing is using ABS Plastic which is stable to 212*F (100*C) and should be sufficient for any application. We made it only with sturdy ABS raw materials. solid walls to ensure the ultimate in durability.
BulletPoint3 : Adapter surrounded with bulge bone which can be striped by flag pole wall,So the adapter can fit dynamic range of 1.5inch-1.6inch inside diameter flag pole(for example Camco/Harbor Freight 20 foot flag pole,Camco flag ploe must be removed the top section of 5 parts then install),Please verify compatibility and you have manipulative ability to install before ordering.
BulletPoint4 : We recommend placing a piece of wood on top of the bushing to prevent damage.you need to use a wooden board and a rubber hammer, put the wooden board on the adapter and hit it gently with the hammer, so that the wall of the flagpole will whittle away the convex part of the adapter.
BulletPoint5 : NOTE:If you have a issue with the installation of the bushing or it was damaged during the process. Please reach out to us to make sure we get you 100 percent squared away. Our goal is to make sure your project is a complete success!
Color : black
ExternallyAssignedProductIdentifier1 : 0658359321903
ExternallyAssignedProductIdentifier2 : 658359321903
GpsrSafetyAttestation : 1
ItemName : FANRTE Pipe Adapter Mount Compatible with Starlink Rectangle Dish, Adapter Bushing for Harbor Freight 20ft Collapsible Flagpole or Camco 20' telecoping Flag Pole
ItemPackageDimensions_Height : 5.8928 centimeters
ItemPackageDimensions_Length : 4.5974 centimeters
ItemPackageDimensions_Width : 4.699 centimeters
ItemTypeKeyword : flagpole-hardware
Manufacturer : fantre
Material : Plastic
ModelName : MK-StarlinkAdapter
ModelNumber : MK-StarlinkAdapter01
PartNumber : MK-SA-01
PowerSourceType : Battery Powered
ProductDescription : The ORIGINAL pole mount adapter bushing! Easily allows the use of a Harbor Freight (p/n 64342, 64344) and Camco(ASIN:B00192JG9O) 20' telecoping Flagpole for mounting a v3 rectangular/square Starlink dish.
You are responsible for making sure your pole fits in this range. You will hammer this bushing into the flagpole (not included) using a piece of wood and a rubber mallet, it will shave the plastic off the ribs to insure a tight fit. line up the screw hole in the pole with the large tab and screw it in. Please make sure to extend the flag pole section you hammer the bushing into out past the length of the bushing.

INSTALLATION INSTRUCTIONS:
1. Remove screw retaining mast topper.
2. Remove topper and discard or store for future use.
3. Orient bushing so the screw holes align with the factory screw hole and push the bushing into place. Note that due to manufacturing tolerances it may require gently tapping the bushing as it is designed as a friction fit with the screw providing additional insurance to avoid twisting or sliding out of the pole.
4. Install the original screw into the hole that aligns with one of the bushing holes.

For Camco flagploe,You must remove the top section of 5 parts then install.
SupplierDeclaredDgHzRegulation : not_applicable
UnspscCode : 39121400