Cart 2 india

Specification
Brand : AXVIO
BulletPoint : Valves
BulletPoint1 : High-quality brass material, environmental-friendly, really sturdy and to use.
BulletPoint2 : G1/2 type water flow , its maximum water pressure is 1.75MPa, the of flow is from 1L/min to 25L/min.
BulletPoint3 : Three wire connection: for positive , black for negative , yellow for pulse signal.
BulletPoint4 : The hall effect is sealed- from the water pipe and allows the to stay safe and dry.
BulletPoint5 : 1X Water Flow
Color : One Color
ExternallyAssignedProductIdentifier : 7320442404048
ItemName : USC-HS21TH Hall Effect Flow Sensor Water 1-30L/min BSPT G1/2" Threaded End Quick Connection 1% Error Turbine flowmeter
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : electronic-component-flow-sensors
Manufacturer : AXVIO
Material : Brass
ModelName : AXVIO
ModelNumber : AXVIO
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : AXVIO
ProductDescription : Valves
USC-HS21TH Hall Effect Flow Sensor Water 1-30L/min BSPT G1/2" Threaded End Quick Connection 1% error Turbine flowmeter
Total length:60mm
Hall Effect Flow Sensor
Model: USC-HS21TH
Application:
Water heater, washing machine, boiler, electromagnetic water heater, water dispenser, water purifier, R.O. machine, U.F. machine, coffee machine, water machine, water machine control, water control machine, beer machine, beauty equipment, shower equipment, electrolytic water machine, energy engineering, heat pump,IC meter, steam equipment, irrigation equipment, water system, campus card self-service (sell) water machine, washing machine, automatic washing equipment, water treatment equipment, water dispensing equipment, cooling system, circulation system, intelligent toilet (toilet), bidet, mechanical equipment, heating equipment, Pharmaceutical (agents) equipment etc.
Calculation Formula: F(Hz)=11*flow rate(Q)-3(l/min)
1. Material: body: brass; turbine: PA66; shaft(axis):SUS304
2. Intubation design of inlet and outlet pipe, easy connection and operation;
3. Imported Hall IC from , stable and reliable;
4. Range: 1-30L/min;
5. working voltage: DC4.5-18V
6. rated voltage: DC5V;/24V
7. Output voltage(rated: DC 5/24V); High level 4.5/23.5V and above; low level 0.5V and below
8. Pulse output duty cycle: 50+-10%
9. Insulation resistance: 100M Ohm and above;
10. Tightness: Seal up all the holes, and inflate with 0.8MPa water, after 1 minute, no leakage and deformation;
11. -20-60 centigrade;
12. Working Pressure: under 0.8Mpa;
13. Electrical Strength: AC500V 50Hz.
Note:
1. When magnetic material is close with the sensor,its characteristics may vary.
2. In order to avoid particle debris, the sensor must beinstalled after a filter.
3. The flow sensor installation has to avoid strong vibration and shaking of the environment, so as not to affect the sensor's measurement accuracy.
ProductSiteLaunchDate : 2024-08-09T09:36:05.677Z
Size : 5V with SM2.54 Plug
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1