Cart 2 india

Specification
Brand : Kuuleyn
BulletPoint1 : 【I.D. Micrometer】: I.D. Micrometer with high quality alloy measuring head, can be used for all kinds of I.D. measurement, fine workmanship, no burr.
BulletPoint2 : 【Bore Micrometer】：Bore Micrometer: engraved lines, easy to read.
BulletPoint3 : 【I.D. Micrometer Set】: I.D. Micrometer Set Micrometer body is made of stainless steel with chrome-plated surface, wear-resistant and sturdy.
BulletPoint4 : 【I.D. Micrometer】: I.D. Micrometer is designed with a locking device, precision mechanical structure to make reading more intuitive and more convenient.
BulletPoint5 : 【 Dimensional Measurement】: Dimensional measurement built-in ratchet stop device, to ensure the accuracy of repeated readings
ExternallyAssignedProductIdentifier1 : 0000930322159
ExternallyAssignedProductIdentifier2 : 000930322159
ItemName : Precision Inside Micrometer,Inside Micrometer,Inside Micrometer Set Hole Bore Internal Diameter Gage Gauge 5‑30mm Range 0.01mm Accuracy Micrometer,Measuring Tool
ItemPackageDimensions_Height : 4 centimeters
ItemPackageDimensions_Length : 17 centimeters
ItemPackageDimensions_Width : 9 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : inside-micrometers
Manufacturer : Kuuleyn
Material : Steel
ModelNumber : Kuuleynns3gbyo2fu
NumberOfItems : 1
PartNumber : Kuuleynns3gbyo2fu
ProductDescription : Specifications:
Type: Inside micrometer
Measuring Range: 5mm~30mm
Material: Stainless steel
Precision: 0.01mm
Weight: 268g(approx.)

Zeroing:
Clean the surface of measuring anvil heads with a soft cloth, then rotate measuring device to make two measuring surface . If two zero lines of differential sleeve and fixed barrel do not alignment, use the following two methods to adjust.
Method I, if the error is less than 0.02mm (0.001), use ratchet stop to lock screw tightly, then use wrench to pull fixed barrel till two zero lines alignment.
Method II, if the error is greater than 0.02mm (0.001 ),
Step1, use ratchet stop to lock screw tightly, then use wrench to loosen the ratchet stop and remove differential sleeve.
Step2, re-align zero lines of fixed barrel and differential sleeve, then put ratchet stop back on. If necessary, adjust it again using method I.
Note: There is no need to calibrate micrometer during common use. Micrometer only need calibration when it is severely worn.

Package Includes:
1 x Inside Micrometer
1 x Wrench
1 x Calibration Ring
1 x Packing Box

Note:

Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.



ProductSiteLaunchDate : 2024-07-31T12:55:42.170Z
Size : 2-6" 303-2215
Style : 0.35-0.425"/8-10mm
SupplierDeclaredDgHzRegulation : not_applicable