Cart 2 india

Specification
Brand : SunnyPro
BulletPoint1 : Compatible with Epson BrightLink pro 585Wi 595Wi 1420wi 1430wi eb-575wi eb-585w powerlite 570 575w 580 585w
BulletPoint2 : Compatible Projector Bare Lamp, Easy to Replace
BulletPoint3 : All lamps are produced by our own factory
BulletPoint4 : All lamps are tested at our factory before leaving the facility
BulletPoint5 : Cheaper Bare Lamp without Housing Also Available for Sale
Color : Elp80-cb
ColorRenderingIndex : 88
ConnectivityTechnology : DisplayPort
ControllerType : Push Button
ControlMethod : application
ControlMethod1 : touch
ControlMethod2 : application
ExternallyAssignedProductIdentifier1 : 606989727107
ExternallyAssignedProductIdentifier2 : 0606989727107
IncandescentEquivalentWattage : 22 watts
ItemName : SunnyPro ELPLP80 V13H010L80 Replacement Projector Lamp Bulb Compatible with Epson BrightLink pro 585Wi 595Wi 1420wi 1430wi eb-575wi eb-585w powerlite 570 575w 580 585w
ItemPackageDimensions_Height : 10.7188 centimeters
ItemPackageDimensions_Length : 9.2964 centimeters
ItemPackageDimensions_Width : 9.398 centimeters
ItemShape : Reflector(R)
ItemTypeKeyword : video-projector-lamps
LightColor : Daylight White
Manufacturer : SunnyPro
Material : Plastic
ModelNumber : ELP80-CB
NumberOfItems : 1
PartNumber : ELP80-CB
ProductDescription : 9 steps to replace the projector lamp
1.Gather the necessary tools, screwdriver.
2.Turn off TV or Projector.
3.Remove Lamp Compartment Door.
4.Remove Lamp Assembly. Carefully pull out the lamp assembly and disconnect any power cords that may still be connected to the lamp assembly. Put it aside and don't get it confused with your new lamp!
5.Clean Lamp Compartment. Dust gets everywhere and while you have the projector open, use a soft cloth or micro-fiber cleaning cloth to remove any loose dust from the lamp compartment.
6.Insert New Lamp Assembly. Carefully reconnect any power cables to the new lamp if present and slide the new lamp into the compartment in the same orientation that the original lamp came out.
7.Replace Lamp Compartment Door. Set the lamp compartment door back into place and securely screw in the door without screwing it in too tightly.
8.Reset the lamp timer. Instructions on how to do this should be covered by the instruction manual.
9.You're Done! Enjoy your projector or TV again and make sure you have a backup lamp handy in case the lights go out unexpectedly.

ProductSiteLaunchDate : 2018-09-10T07:00:00.000Z
SpecificUsesForProduct : Lamp
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 45111600
Voltage : 120 volts_of_alternating_current
Wattage : 100 watts