Cart 2 india

Specification
AcceptedVoltageFrequency : 100v_240v_50hz_60hz
Brand : SunnyPro
Brightness : 2000 lumen
BulletPoint1 : Compatible lamp for VIEWSONIC PJD5155 PJD5255 PJD5153 PJD5353LS PJD6350 PJD5151 PJD5555W PJD5553LWS PJD6550LW
BulletPoint2 : Projector Lamp with Housng
BulletPoint3 : All lamps are produced by our own factory
BulletPoint4 : All lamps are tested at our factory before leaving the facility
BulletPoint5 : Cheaper Bare Lamp without Housing Also Available for Sale
Color : Rlc-092-cb
ControlMethod : application
ExternallyAssignedProductIdentifier1 : 606989725752
ExternallyAssignedProductIdentifier2 : 0606989725752
IncandescentEquivalentWattage : 350 watts
IndoorOutdoorUsage : indoor
ItemName : SunnyPro Projector Lamp Bulb RLC-092 / RLC-093 Replacement for VIEWSONIC PJD5155 PJD5255 PJD5153 PJD5353LS PJD6350 PJD5151 PJD5555W PJD5553LWS PJD6550LW
ItemPackageDimensions_Height : 11 centimeters
ItemPackageDimensions_Length : 9 centimeters
ItemPackageDimensions_Width : 9.4 centimeters
ItemPackageQuantity : 1
ItemShape : Bulb
ItemTypeKeyword : video-projector-lamps
LightType : LED
Manufacturer : SunnyPro
Material : Plastic
NumberOfItems : 1
PartNumber : RLC-092-CB
ProductDescription : 9 steps to replace the projector lamp
1.Gather the necessary tools, screwdriver.
2.Turn off TV or Projector.
3.Remove Lamp Compartment Door.
4.Remove Lamp Assembly. Carefully pull out the lamp assembly and disconnect any power cords that may still be connected to the lamp assembly. Put it aside and don't get it confused with your new lamp!
5.Clean Lamp Compartment. Dust gets everywhere and while you have the projector open, use a soft cloth or micro-fiber cleaning cloth to remove any loose dust from the lamp compartment.
6.Insert New Lamp Assembly. Carefully reconnect any power cables to the new lamp if present and slide the new lamp into the compartment in the same orientation that the original lamp came out.
7.Replace Lamp Compartment Door. Set the lamp compartment door back into place and securely screw in the door without screwing it in too tightly.
8.Reset the lamp timer. Instructions on how to do this should be covered by the instruction manual.
9.You're Done! Enjoy your projector or TV again and make sure you have a backup lamp handy in case the lights go out unexpectedly.

ProductSiteLaunchDate : 2018-09-10T07:00:00.000Z
SpecificUsesForProduct : Lamp
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 45111600
Voltage : 240 volts
Wattage : 200 watts