Cart 2 india

Specification
Brand : Orings-Online
BulletPoint1 : For use across a wide temperature range from -30 degrees F to 250 degrees F, Good/Excellent resistance to many petroleum oils/greases, hydraulic fluids, alcohol, mineral oil and grease
BulletPoint2 : Oil resistant applications of all types. Low temperature military uses. Off-road equipment. Automotive, marine, aircraft fuel systems
BulletPoint3 : Compatible with Aliphatic Hydrocarbons (propane, butane, petroleum oil, mineral oils and greases, diesel fuel and fuel oil)
BulletPoint4 : Not Compatible with product fuels with a high aromatic content; aromatic hydrocarbons (benzene); Chlorinated hydrocarbons (Trichloroethylene)
BulletPoint5 : Buna N or Nitrile has good mechanical properties when compared with other elastomers and high wear resistance. Good/Excellent resistance to many petroleum oils/greases, hydraulic fluids, alcohol, mineral oil and grease; 70 Durometer
Color : Black
ItemName : 009 Standard Dash Size -009 Buna-N NBR O-Rings Bulk, 70 Durometer, Black, 7/32" ID, 11/32" OD, 1/16" Cross Section (50 Pack/Pieces)
ItemPackageDimensions_Height : 1.27 centimeters
ItemPackageDimensions_Length : 11.938 centimeters
ItemPackageDimensions_Width : 9.906 centimeters
ItemPackageQuantity : 1
ItemShape : Round
ItemTypeKeyword : o-ring-seals
Manufacturer : Orings-Online
Material : Nitrile (Buna-N, NBR)
ModelNumber : ORBN134x50
NumberOfItems : 50
PartNumber : OO-009-70-50
ProductDescription : Nitrile is the one of the most widely used rubber materials, due to its combination of low cost, resistance to many chemicals, and good physical properties. The acrylonitrile content of this highly polar elastomer provides excellent oil and gas permeation resistance, which increases as the level of ACN increases. However, an increase in the acrylonitrile content compromises low temperature flexibility, and increases compound hardness. Typical ACN content ranges from 18% to 50%. Nitrile should not be exposed to direct sunlight or moderate to high levels of atmospheric ozone, as rapid deterioration will result. However, NBR will accept many anti-degradants, most notably PVC, which offer some degree of improvement of these deficiencies. Nitriles are usually sulfur cured, but peroxide curing is also possible, resulting in improved compression set. Buna-nitrile can have high tensile strength, and abrasion, tear, and compression set resistance. It can be used in temperatures between -30 degrees F (-34 degrees C) to 250 degrees F (121 degrees C), and is compatible for use with petroleum, HFA, HFB and HFC fluids, vegetable oil, alcohol, acids and aliphatic hydrocarbons. These Buna O-rings have a shore durometer (Hardness of a material, and its resistance to permanent indentation) listed in the title above. A higher durometer value indicates greater resistance to indentation. O-rings commonly provide a pressure and fluid seal between cylindrically shaped, overlapping mating surfaces and are commonly seen in engines, faucets, flanges, valves, and various cylinders. They are circular in shape, with a round cross section, and a hole in the center, similar to a doughnut. O-rings are available in various sizes, and can be ordered based on required nominal inside diameter (ID), outer diameter (OD), and cross-sectional (CS) diameter. **Note: The picture shows an example of the o-rings, you will receive an item of similar design in the amount and specifications stated in the title.
UnitCount : 50
UnspscCode : 31410000