Cart 2 india

Specification
Brand : Vintage Electronics
BulletPoint : Preamps
BulletPoint1 : DIY Pinch Roller Rebuilt
BulletPoint2 : No special tools needed
BulletPoint3 : Takes just a few minutes to replace
BulletPoint4 : Fits into standard single-gang low-voltage junction boxes or mounting brackets.
BulletPoint5 : Used to do the microphone pre-amplification is very good, very low noise and AC ripple, the output signal voltage greater than 1V or more, to promote the post-amplifier signal value is very strong.
Color : One Color
CompatibleDevices : Car
ExternallyAssignedProductIdentifier : 7310083203865
ExternallyAssignedProductIdentifier1 : 0608460304746
ExternallyAssignedProductIdentifier2 : 608460304746
IncludedComponents : 2pcs Amplifier Module
ItemName : Pinch Roller Replacement Tire for Tascam 44 (Early)
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : tape-decks
Manufacturer : Vintage Electronics
Material : Rubber
MaximumSupplyVoltage : 15 volts_of_direct_current
MinimumSupplyVoltage : 3 volts_of_direct_current
ModelName : LM386AMP-2P-G
ModelNumber : YTMJPQQJI
MountingType : Surface Mount
NumberOfBoxes : 1
NumberOfChannels : 1
NumberOfItems : 1
OutputPower : 750 watts
PackageTypeName : box
PartNumber : VEteacPR
ProductDescription : Brand new replacements for the rubber on the Tascam 44 (Early) pinch rollers. Rebuild the roller yourself and save. Just cut off the old rubber, clean the bearing, and install the new rubber tire on the rollers. You will have a brand new roller at half the cost of getting it rebuilt. Rollers come with a Lifetime Warranty.
ProductSiteLaunchDate : 2017-03-10T08:00:00.000Z
Size : One Size
StreetDate : 2020-05-04T00:00:01Z
Style : 100W
SupplierDeclaredDgHzRegulation : not_applicable
SupplyCurrent : 150 milliamps
UnitCount : 1
UnspscCode : 45111700
Voltage : 3 volts_of_direct_current
WarrantyDescription : 1
Wattage : 20 watts