Cart 2 india

Specification
Brand : Generic
BulletPoint1 : Eal data from OBD 2 Port, Display Car Speed, water temperature, Oil temperature, voltage, fuel consumption, RPM, single mileage, total cumulative mileage, driving time, system time, intake pressure, air-fuel ratio, pressure(if your car engine has no turbo funtion, then this function will be invalid), intake pressure,speed up test, brake test, read data stream. Engine Faulty number
BulletPoint2 : Alarm for: Overspeed alarm,High water temperature , Low voltage, Engine fault,
BulletPoint3 : Smart Fuctions: Clear fault code, Switching between kilometer and miles, and Fahrenheit .
BulletPoint4 : 【Multiple functions】: Ambient decorative lighting Engine RPM Fault code alarm Fatigue driving alarm .The Alarm Light sensor: HUD can automatically adjust the brightness "according to the environment .Speed unit: KM/H, MPH .Multi-function zone: speed,water temperature,battery voltage,driving distance Water temperature ,voltage.
BulletPoint5 : 5. Up to 10 Hz refresh rate, there will be no lag delay, more than 100 kinds of data can be displayed, and it can be used for all cars, vehicles and trucks on the market.
ExternallyAssignedProductIdentifier : 9446289136480
ItemName : A2 HUD 3.5 inch GPS Car Head Up Display Speed Alarm Compass Windshield Projector Speedometer HUD via GPS Satellites
ItemPackageQuantity : 1
ItemTypeKeyword : vehicle-overhead-video
Manufacturer : Lifyn2
Material : Glass
NumberOfItems : 1
PartNumber : 32951475862
ProductDescription : A2 GPS HUD Main Features:
1. Collecting speed from GPS satellites, available for all cars, easy to install, plug and play
2. Screen 3.5 inch HD display
3. Multi-color design makes the screen more abundant and easier to read
4. Nano-technology to eliminate double reflections,more clear.
5. Rich Contents: speed,compass, speed alarm,free switch between km and miles
6. Auto power on/off: HUD start and off with vehicle started and shutdown, effective protection of the car battery;retaining the manual switch mode,more easy to control HUD.
7. Automatic and manual brightness adjustment mode,driving without glare
Reflective film installation:
Using the unit without the reflective film may result in a double image observed by the user depending on the windshield. If you see a double layer it is due to the windshields dual layer construction and you should install the film by following the instructions below:
1. Place the supplied non-slip mat in the desired position on the dashboard with the HUD on top.
2. Observing where the HUD reflects place the reflective film in position.
a. Ensure the surface is clean and dry before installing the film;
b. Remove the back protective side marked (1) and attach the film to the clean windscreen;
c. Once you’re satisfied with the location use a credit card or similar to remove any bubbles or air pockets that remain;
d. Remove the front side marked (2), pls adjust the place of nonslip mat to make information can be fully display
Package Contain:
1 x A2 Head Up Display
1 x Car Charge Cable
1 x Reflective Film
1 x Antiskid Pad
1 x User Manual
ProductSiteLaunchDate : 2022-08-26T08:00:54.063Z
UnspscCode : 25174400