Cart 2 india

Specification
AutoPartPosition : rear
Brand : TOPZONE
BulletPoint1 : Fitment: 2008-2009 Hypermotard 1100 / 1100S; 2010-2012 Hepermotard 1100 EVO/ 1100 EVO SP; 2010-2012 Hypermotard 796
BulletPoint2 : Packing: 1 PCS of taillight + 1 bag of resistors and other accessories
BulletPoint3 : Running light / position light : red color; Stop light / brake light : red color more powerful when you are braking
BulletPoint4 : Integrated turn signals indicators : amber color on each half of the taillight (wires are independent)
BulletPoint5 : For Sequential LED Taillight, Search ASIN: B07B49W2BC / B07B49VLFK
BulletPoint6 : For Clear Color LED taillight, Search ASIN: B01N6Q3ZU0
Color : Smoke
CompatibleWithVehicleType : Motorcycle
ExternallyAssignedProductIdentifier1 : 815726028715
ExternallyAssignedProductIdentifier2 : 0815726028715
ItemName : TOPZONE LED Brake Taillight Integrated Turn Signal For Ducati 2009-2010-2011-2012 Hypermotard (Smoke Color)
ItemPackageDimensions_Height : 8 inches
ItemPackageDimensions_Length : 14 inches
ItemPackageDimensions_Width : 10 inches
ItemPackageQuantity : 1
ItemTypeKeyword : powersports-tail-light-assemblies
Manufacturer : dingdong
PartNumber : TZD-214-INT-S-TL
ProductDescription : TOPZONE LED Brake Taillight Integrated Turn Signal For
Ducati
2008-2009 Hypermotard 1100 / 1100S;
2010-2012 Hepermotard 1100 EVO/ 1100 EVO SP;
2010-2012 Hypermotard 796



Running light / position light : red color
Stop light / brake light : red color more powerful when you are braking
Integrated turn signals indicators : amber color on each half of the taillight (wires are independent)
To slow down the blinking rate use provided resistors if necessary:

Wiring Diagram applicable to most bikes:
Black Wire(Negative),
Green Wire(Brake)
Red Wire(Running Light)
1. Connect one end of the resistor to the ground wire on your turn signal harness from your bike.
2. Connect the other end of the resistor to both the YELLOW wire from our taillight and the positive
turn signal wire from your turn signal harness from your bike.
3. Repeat the same process for the other side. To use the red connectors, place one wire inside along one channel, place another wire inside along the other channel. Push down the metal pin as it will make a small cut on each wire bridging the connectors.
if you are using the resistors, place one end of the resistor in the middle of either channel along with the one wire.

Quality Guarantee： return and full re-fund if any quality issues.
Our service: 7 days/ 24hours service available. Most emails can be replied within 24 hours including weekends and holidays.
( Due to different time zone, some maybe delayed).

ProductSiteLaunchDate : 2017-01-12T02:43:04.630Z
SpecificUsesForProduct : Taillight
UnspscCode : 25172900
Voltage : 12 volts
WarrantyDescription : 6 month