Cart 2 india

Specification
Brand : AGKNX
BulletPoint1 : Hydraulic Log Splitter Pump 16 GPM @ 3600RPM
BulletPoint10 : Rotation is counterclockwise
BulletPoint2 : Shaft: ½”
BulletPoint3 : Inlet port: 1”
BulletPoint4 : Outlet port: ½”
BulletPoint5 : 7- 1/4" L with shaft, 5- 5/8” L without shaft
BulletPoint6 : 3” across body, 3 -3/8” across mounting surface
BulletPoint7 : Minimum 8 HP or larger gas engine, direct drive only, horizontal shaft (can be mounted vertical or horizontal)
BulletPoint8 : Bolt circle: 2.83in.
BulletPoint9 : Mounting hole diameter: .344in.
Color : Aluminum
ConnectorType : Cap
ExteriorFinish : Painted
ExternallyAssignedProductIdentifier1 : 0819686024220
ExternallyAssignedProductIdentifier2 : 819686024220
FinishType : Powder Coated
FitType : Vehicle Specific
IncludedComponents : Hydraulic Pump
ItemName : Log Splitter Hydraulic Pump - COUNTERCLOCKWISE Rotation 16GPM
ItemPackageDimensions_Height : 5 inches
ItemPackageDimensions_Length : 9 inches
ItemPackageDimensions_Width : 6.5 inches
ItemPackageQuantity : 1
ItemTypeKeyword : hydraulic-pumps
Manufacturer : AgKnx
Material : Plastic
ModelName : Log Splitter Hydraulic Pump - COUNTERCLOCKWISE rotation 16GPM
ModelNumber : 31-258
NumberOfBoxes : 1
NumberOfItems : 1
OemEquivalentPartNumber : SP0170
PartNumber : AL161043
PowerSourceType : Air Operated
ProductDescription : Replacement for the Swisher log splitter vertical shaft and counterclockwise belt driven pump. The 2-stage pump can give you faster cycle times and higher possible pressure with a small engine.  Excellent for use on log splitters.  85% efficient. Suggested applications: Presses, Log Splitters, Clamping Units and Compactors Flow rates on the hi-low tandem pumps are 0.256 cu in/rev on the low flow and 0.793 cu in/rev on the high flow pump. This 2 stage pump can give you much faster cycle times and higher possible pressures with a small engine. Excellent for use on log splitters. 85% efficient. This is a HI/LO hydraulic gear pump with 12 different displacement combinations with maximum pressures of 900 psi for the low pressure pump and 3000 psi for the high pressure. The change from LO to HI pressure is automatic with the LO side pressure pre set from 400 psi to 900 psi. The HI/LO section of the pump is all aluminum and the end plates are cast steel. Applications for the HI/LO pump are log splitters, presses etc where rapid movement of the cylinder at low pressure is required prior to automatically switching to the high pressure mode to meet load requirements.
ProductSiteLaunchDate : 2024-05-28T20:14:25.757Z
Style : Diaphragm
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1
UnspscCode : 40151500
WarrantyDescription : 1 year