Cart 2 india

Specification
Brand : CH4X4 INDUSTRIES
BulletPoint1 : Only White LED lights Color, Single Pole, Single Throw ON-OFF switch
BulletPoint2 : Gray hard surface rocker cap, Double LED light on every switch
BulletPoint3 : Upper LED is ON only when the switch is turned ON, Lower LED is independent, Both LEDs have separate grounds
BulletPoint4 : Same size as the Carling switches, Rated 20A AT 12V/10A AT 24V, No rear barriers between terminals
BulletPoint5 : Weather proof, Easy to install, wiring diagram supplied with switch
Color : White
ConnectivityProtocol : X-10
ConnectorType : Plug In
CurrentRating1 : 20 amps
CurrentRating2 : 10 amps
ExternallyAssignedProductIdentifier1 : 711811418907
ExternallyAssignedProductIdentifier2 : 0711811418907
InternationalProtectionRating : IP54
ItemName : CH4X4 Rocker Switch 4X4 Symbol - Horizontal - Red Led
ItemPackageDimensions_Height : 8.9 centimeters
ItemPackageDimensions_Length : 2.7 centimeters
ItemPackageDimensions_Width : 8.1 centimeters
ItemPackageQuantity : 1
ItemShape : Round
ItemTypeKeyword : boating-rocker-switches
Manufacturer : CH4X4 INDUSTRIES
Material : Copper
MountingType : Pole,Surface
NumberOfPositions : 1
OperatingVoltage : 24 volts
OperationMode : ON-OFF
PartNumber : CH4X4-4X4H-R
ProductDescription : CH4x4 Gray Series Rocker Switches are single throw ON/OFF, designed to operate all of your 12v accessories or devices. Our Switches have many applications, from turning ON and OFF lights to powering winches, air horns, freezers, cooling fans, winch power, and even zombie lights. All symbols are laser etched directly onto the switch face to ensure long lasting image life. We do not use stickers, paint or ink in our switches, which will wear off in a very short time, this also gives the switch a more styling and clean design. ---------- These switches have a surface of 2” (50mm) x 1” (25mm) and they use a standard din size mounting hole of 1.50” (38mm) x 0.82” (21mm); these are the standard size measurements. Our switches come packed with instructions on the back of each of them and we also have our technical support staff here to help you. ---------- NOTE: These switches are not intended or manufactured to replace original manufacturer equipment or switches that came in your vehicle from factory, in many cases you will have to trim/cut or adapt the mounting hole for the switch to fit, we have many adapters or switch panels and pods that will help you install them in your vehicles depending on the application. Please make sure you verify if your vehicle is compatible with adding additional switches since there are many vehicles out in the industry with different set ups. Also check with a Mobile audio and electronics professional to make sure you are getting the correct installation for your vehicle. (CONTACT US IF NOT SURE IF IT FITS YOUR VEHICLE BEFORE YOU BUY) . ----------
ProductSiteLaunchDate : 2017-02-01T17:19:18.314Z
SupplierDeclaredDgHzRegulation : not_applicable
SwitchType : Rocker
TerminalType : Button,pin
UnitCount : 1
UnspscCode : 39122200