Specification Brand : DERNORD BulletPoint1 : Fits 2 Inch Tri-clamp,and easy tighten thumb screw BulletPoint2 : Made of stainless steel 304,Higher corrosion resistance than the 302 grade stainless steel BulletPoint3 : Preventing rust processes and for the whole body BulletPoint4 : Fit for all other homebrew stuff sanitary fittings BulletPoint5 : The bolts,lock nuts and brass hex nuts can be replaced easily as needed Color : Multicolor Color1 : Silver Color2 : Gold ConnectorType : Cap CustomerPackageType : Standard Packaging ExteriorFinish : Stainless Steel ExternallyAssignedProductIdentifier1 : 698253849226 ExternallyAssignedProductIdentifier2 : 0698253849226 GpsrSafetyAttestation : 1 IncludedComponents : 6 x Sanitary fitting cap ItemName : DERNORD Sanitary Clamp High Pressure Bolted Tri Clamp Clover Stainless Steel 304 (Tri-clamp: 2 Inch) ItemPackageDimensions_Height : 14.7066 centimeters ItemPackageDimensions_Length : 2.2098 centimeters ItemPackageDimensions_Width : 12.0904 centimeters ItemPackageQuantity : 1 ItemTypeKeyword : sanitary-tube-fittings Manufacturer : DERNORD Material : Stainless Steel ModelName : Hotop ModelNumber : DERNORD-489 NumberOfItems : 6 NumberOfPieces : 6 PartNumber : DERNORD-489 ProductDescription : DERNORD High Pressure Clamps are constructed from 304 stainless steel and intended for use with sanitary Tri-Clamp fitting connections. Bolted double pin high pressure clamps are a significant upgrade from the standard clamp, with the ability to withstand twice the pressure of comparable sized single or double hinged clamps. High pressure bolted clamps are available in stainless steel SS304, with sizes ranging from 3/4 inch up to 12 inches. Larger sizes are available by special order. Intended for Tri Clamp fitting connection, high pressure clamps are commonly used in situations where temperatures fluctuate and PTFE gaskets are installed.
DERNORD recommends that all high pressure clamps be tightened as per the table under "Specificiations" to apply proper pressure and ensure a solid, leak free seal. However, over tightening a high pressure clamp may cause the gasket to fail from over-compression and place too much tension on the clamp threads