Cart 2 india

Specification
Brand : Jamo
BulletPoint : DOUBLE UCP BLANK PNL
BulletPoint1 : Frequency Response (Hz, +/-3dB) 35-20,000
BulletPoint2 : Volume Control
BulletPoint3 : Ivory
BulletPoint4 : The Jamo AT-1A is a rotary-type volume control in a decorator-style plate.
BulletPoint5 : Certification：CE, FCC, RoHS
CircuitType : 2-way
CompatibleDevices : Laptop
ConnectorType : Wire
ExternallyAssignedProductIdentifier : 5709009940632
ExternallyAssignedProductIdentifier1 : 656747022906
ExternallyAssignedProductIdentifier2 : 0656747022906
ItemDisplayDimensions_Height : 10.19 inches
ItemDisplayDimensions_Width : 3.49 inches
ItemName : JAMO Rotary-Type Volume Control Ivory
ItemPackageDimensions_Height : 1 millimeters
ItemPackageDimensions_Length : 1 millimeters
ItemPackageDimensions_Width : 1 millimeters
ItemPackageQuantity : 1
ItemTypeKeyword : audio-video-selectors
Manufacturer : Jamo
Material : Plastic
ModelNumber : UCPB2
MountingType : Wall Mount
NumberOfBoxes : 1
NumberOfItems : 1
NumberOfPositions : 2
OperationMode : manual
OutputWattage : 43
PartNumber : UCPB2
ProductDescription : Frequency Response (Hz, +/-3dB) 35-20,000 The Jamo AT-1A Volume control can be used as a volume control for one pair of speakers. PLACEMENT The AT-1A should not be located close to light switches/dimmers as this may cause a hum in the speakers. If the AT-1A is located close to these devices it must be mounted in a separatly grounded electrical box. Speaker cables/wires should also be as far away from electrical wires as possible. INSTALLATION The amplifier must be turned OFF before you install the AT-1A and/ or speakers or it may cause damage to the amplifier. Connect the speaker output on the receiver/amplifier to the INPUT on the AT-1A. Connect the OUTPUT from the AT-1A to the left and right speakers When connecting speaker cables/wires from the amplifier to the AT-1A and from the AT-1A to the speakers make sure LEFT (L) is connected to LEFT (L), RIGHT (R) to RIGHT (R), POSITIVE (+) to POSITIVE (+) and NEGATIVE (-) to NEGATIVE (-). If terminals are colour coded, RED is POSITIVE (+) and BLACK is NEGATIVE (-). SET-UP Before turning on the amplifier turn the amplifier volume to minimum. Turn the AT-1A to maximum volume (clockwise). Turn the amplifier on and slowly turn up the volume to the highest desired level without distortion from the speakers. The volume of the speakers are now controlled by the AT-1A and the amplifier volume control should not be used.
ProductSiteLaunchDate : 2012-11-22T17:53:27.901Z
StreetDate : 2021-05-28T00:00:01Z
SupplierDeclaredDgHzRegulation : unknown
SupplierDeclaredHasProductIdentifierExemption : 1
SwitchType : Rotary
TerminalType : Screw
UnitCount : 1
UnspscCode : 52161500
WarrantyDescription : NO