Cart 2 india

Specification
Brand : PCS
BulletPoint1 : Eliminates problems with LEDs flickering or not turning off
BulletPoint2 : Dissipates only 1.4W at 100 percent brightness
BulletPoint3 : At lower brightness levels, dissipates even less than 1.4W
BulletPoint4 : Can install behind dimmer switch or at load
ExternallyAssignedProductIdentifier1 : 811976014294
ExternallyAssignedProductIdentifier2 : 0811976014294
ItemName : PCS 10K Load Resistor for LED Lighting (ILR-10K)
ItemPackageDimensions_Height : 13.3096 centimeters
ItemPackageDimensions_Length : 1.8034 centimeters
ItemPackageDimensions_Width : 8.9916 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : single-resistors
Manufacturer : Powerline Control Systems
Material : copper
ModelNumber : CECOMINOD016098
PartNumber : ILR-10K
ProductDescription : If your LED fixtures or bulbs have issues with turning off all the way or flickering at specific dim levels, use the PCS 10K Load Resistor for LED Lighting to solve this problem. The resistor wires in parallel with the LED load between the switch load wire (RED) and the neutral wire (WHITE). Because the resistor dissipates only 1.4W at 100 percent brightness, its heat generation is minimal enough that it can be placed directly behind a dimmer switch or right at the load/fixture. At lower brightness levels, dissipates even less than 1.4W. NOTE: Must be wired in parallel, not in series. Installation must be carried out by a qualified electrician only. The circuit breaker or WS1DL must be turned off during installation. Installation must be carried out in accordance with all applicable codes and requirements, including, but not limited to, the National Electrical Code (NEC). Manufacturer Part #: ILR-10K.
ProductSiteLaunchDate : 2016-04-24T05:06:50.089Z
Size : 1 Set
UnitCount : 1
UnspscCode : 32111500