Cart 2 india

Specification
Brand : Generic
BulletPoint : 3/16oz BRASS BULLET SINKERS, 10 PER PACK BY S & J's TACKLE BOX
BulletPoint1 : Dimatteo Bean Sinker Mold：5 cavities and 1-ounce, without handle
BulletPoint2 : Making Professional Bank Sinker at Home: With this product, you can make professional bank sinker at home
BulletPoint3 : Provide a Money Saving Solution for Fishing Enthusiasts: Long term purchase of this type of bank sinker will cost a lot of money, and this sinker mold provides consumers with a better choice. you can make a large number of cheap bank sinker at home for a long time
BulletPoint4 : Easy to Use: This mold is easy to use for both novice and experienced fishing enthusiasts, and can help you easily make professional bank sinker
BulletPoint5 : Handmade DIY: You can enjoy the fun of DIY while making bank sinker, feel the sense of achievement brought by making bank sinker, and bring a different fishing experience to you
Color : Silver
ExternallyAssignedProductIdentifier1 : 0667016086727
ExternallyAssignedProductIdentifier2 : 667016086727
ItemDisplayWeight : 0.3 kilograms
ItemName : Dimatteo Bean Sinker Mold With 5 Cavities and 1-Ounce, Without Handle
ItemPackageDimensions_Height : 1.9 inches
ItemPackageDimensions_Length : 10.6 inches
ItemPackageDimensions_Width : 1.9 inches
ItemPackageQuantity : 10
ItemShape : Oval
ItemTypeKeyword : fishing-sinkers-and-weights
Manufacturer : Dimatteo
Material : Lead
NumberOfPieces : 1
ProductDescription : Bean Sinker Mold With 5 Cavities and 1-Ounce, without handle. How to make sinkers: 1. Ensure you are wearing protective clothing and all care must be taken when heating and pouring lead. 2. Put scrap lead into saucepan and heat until molten (lead will normally melt at 650 degrees). 3. Once lead is molten use a cooking spoon to take away any impurities that have risen to the top. 4. Take your coat hanger wire (wire is only used when making sinkers that require a hole in the centre) and place within the mould. 5. Using the tongs grab tour mould carefully and have the pouring cavity facing you. 6. Pour molten lead into mould until cavity is full. 7. It is recommended the mould be preheated before use. 8. Once mould has been heated up and your lesd is fully molten and clean you can proceed to pour the lead in to the cavity. 9. Wait 10 seconds and using pliers pull wire out then proceed to open mould. 10. Using your pliers snip the excess lead of the top of the sinkers. 11. Good luck and remember to always take care. 12.When disposing of unwanted lead please take note of your local authority about appropriate methods. Warning: 1. Lead is a toxic material 2. Use PPE when handing moulds 3. Use dry moulds as water can cause molten lead to explode
ProductSiteLaunchDate : 2022-10-17T09:26:33.367Z
Size : 3/16
SupplierDeclaredDgHzRegulation : not_applicable
UnspscCode : 52151600
VolumeCapacityName : 28.35 ml