Cart 2 india

Specification
Brand : GEiNNOVA
BulletPoint1 : Flux-Gel conforming to EN 61190-1-1 REL0 DIN EN 29454 1.2.3.C (DIN 8511 F-SW 32).
BulletPoint2 : Matedex Multifix 450-01 was especially developed for rework and repair. It is a resin based, no-clean, tacky flux, suitable for manual and automatic dispensing, with good printability and fine dispensability.
BulletPoint3 : The extreme low activation causes an excellent insulation reaction of the flux residues after soldering.
BulletPoint4 : Therefore Multifix 450-01 is excellently suitable for many applications in electronics.
BulletPoint5 : The residues of Multifix 450-01 dry quickly, are hard and not sticky. If necessary they can be removed by our cleaner Matedex Flux-Ex 500.
IncludedComponents : w/plunger & tip
ItemName : Flux-Gel 10 g Flux-Gel Multifix450-01 No Clean,Halide free, in 30cc syringes for manual dispensing
ItemTypeKeyword : solder-flux
Manufacturer : STANNOL
Material : copper
ModelName : GEMF450-010
ModelNumber : GEMF450-010
ProductDescription1 : Apply a sufficient quantity of Multifix 450-01 manually or with a compressed air dispenser. The soldering temperature should not exceed 350°C. To evaporate the solvent make sure that the flux is heated above 100°C. This assures a non sticky film.
ProductDescription2 : Acid Value:65-75 mg KOH/g; Viscosity:450-650 Pa*s; Halide content: N/A;
ProductDescription3 : Water content:<0.5%; Density (at 20°C): 0.82 g/cm3; Flash Point (closed crucible): 93°C
ProductDescription4 : Change of surface resistance DIN 8527: Pass
ProductDescription5 : Corrosion DIN 8527 / Copper mirror test: Pass
ProductSiteLaunchDate : 2023-11-16T03:44:45.067Z
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1