Cart 2 india

Specification
Brand : Ganivsor
BulletPoint1 : Replacement Wick Kerosene Heater Wick# AW-500
BulletPoint2 : Fits: Perfection 0525M, 730, 735, 750G & all earlier models, Valor 525 & 555
BulletPoint3 : For installation steps, please see Product Description
BulletPoint4 : Tips for use: 1. You will need to pre-burn the top edge of the wick before you put in the tank, so that the top is level and doesn't smoke. To do this, after you install the wick and while you have the flame spreader removed, raise it so that all of the top edge of the wick is slightly above the top of the wick tubes.
BulletPoint5 : 2. Squirt cigarette lighter fluid all along the top edge of the wick and light it. It will burn for a few minutes until it is burned down even with the top of the wick tube, then it will go out. Take the edge of a knife and scrape it until the top edge is all even with the top of the tubes. The wick is now level and you can fill the tank and light it up and enjoy!
Color : White
GpsrSafetyAttestation : 1
ItemName : Ganivsor AW500 Wick for Kerosene Heat MfrPartNo AW-500 American Wick Fits Many Perfection Models
ItemPackageDimensions_Height : 19.7 centimeters
ItemPackageDimensions_Length : 7.2 centimeters
ItemPackageDimensions_Width : 13.3 centimeters
ItemTypeKeyword : space-heater-replacement-parts
Manufacturer : Gavin Parts Shop
ModelName : Wick
ModelNumber : AW500
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : AW-500
ProductDescription : For American Wick Kerosene Heater Wick #AW-500 NEW Fits many perfection models

Fits KEROSENE HEATER WICK

AW-500

Up for bids is one American Wick Kerosene Heater Wick # AW-500

Fits Perfection 0525M, 730, 735, 750G, and all earlier models
Also fits Valor 525 & 555

FITTING INSTRUCTIONS

1.Remove Oil Reservoir from Heater
2.Remove Flame Spreader.
3.Unscrew and Remove Gallery.
4.Wind old Wick up as far as possible andextract Carrier and Wick.
5.Place split end of new Wick over centra!Tube.Line up slots on Carrier with CogWheel making sure that split in the fabricis on either side of the Cog Wheel.
6.Push carrier down to engage Cog Wheeland adjust to lowest level.
7.Replace Gallery and Flame Spreader.
8.Allow Wick to soak for at least 15minutes before lighting.

HANDLE YOUR NEW WICK WITH CARE


ProductSiteLaunchDate : 2024-09-23T09:08:08.079Z
SupplierDeclaredDgHzRegulation : unknown
SupplierDeclaredHasProductIdentifierExemption : 1
UnspscCode : 53000000