Cart 2 india

Specification
Brand : Irnyso
BulletPoint1 : fits T100-220 40445 Crown Electrode Setting Gauge
BulletPoint2 : Universal Oil Burner Electrode Setting Gauge. Accurately sets electrode gap and placement from the nozzle based on nozzle spray angle.
BulletPoint3 : Ignitor Gauge Universal Electrode Adjusting Tool that Accuratrely sets the electrodes to the proper angle relative to the degree rating of the
BulletPoint4 : This is a Eureka replacement part
BulletPoint5 : Part Number 27871
BulletPoint6 : This is an O.E.M. part
CareInstructions : NO
CircuitType : 2-way
Color : Blue
ConnectivityProtocol : X-10
ConnectorType : 2 Pin
ControlMethod : touch
ExternallyAssignedProductIdentifier1 : 708088533105
ExternallyAssignedProductIdentifier2 : 0708088533105
GpsrSafetyAttestation : 1
IncludedComponents : Universal Oil Burner Electrode Setting Gauge Tool 40445
InternationalProtectionRating : IP00
ItemDisplayWeight : 0.01 pounds
ItemName : Replacement Universal Oil Burner Electrode Setting Gauge Tool 40445 T100-220 Fits Beckett Carlin Aero Wayne Westwood etc heater
ItemPackageDimensions_Height : 6.7056 centimeters
ItemPackageDimensions_Length : 3.6068 centimeters
ItemPackageDimensions_Width : 5.4102 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : space-heater-replacement-parts
Manufacturer : Irnyso
Material : Plastic
ModelName : Universal Oil Burner Electrode Setting Gauge Tool
ModelNumber : 40445
MountingType : Panel Mount
NumberOfItems : 1
OemEquivalentPartNumber : DA97-13728G
OperationMode : manual
PartNumber : 40445
ProductDescription : Universal Oil Burner Electrode Setting Gauge. Accurately sets electrode gap and placement from the nozzle based on nozzle spray angle. Works With Riello, Carlin, Beckett, Wayne Aero Crown and Many Other Oil Burners Replaces Westwood T100-220, Ignitor Gauge Universal Electrode Adjusting Tool that Accuratrely sets the electrodes to the proper angle relative to the degree rating of the Remove the draw / Ignitor / Electrode Assembly from the burner. Loosen the electrode Clamp. Place the Gauge over the end of the nozzle with the corresponding spray degree rating of the nozzle (45, 60, 70, 80, or 90*) in the upright position up against the nozzle face. See photo above. Adjust electrodes so they are seated as above. It may be necessary to slightly bend the electrodes. Tighten the electrode screw, make minor adjustments so the tool slides on and off with little resistance. That's it!Nozzle.
ProductSiteLaunchDate : 2024-10-06T07:05:47.224Z
Size : NO
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
SwitchType : Rocker
TerminalType : Screw
UnitCount : 1
UnspscCode : 52150000
WebsiteShippingWeight : 0.948 kilograms