Description:
SV4401A for International Version 7 inch IPS LCD Display 100dB Dynamic 50KHz-4.4GHz Vector Network Antenna Analyzer Kits VNA Tester Built-in 8GB Memory Card
Feature:
. Measurement frequency range: 50KHz-4400MHz;
2. RF output : adjustable from-12dbm to-42dbm(step 1db)(error in the whole frequency band: plus or minus 1db);
3. Frequency accuracy:±1ppm,±5KHz>140MHz
4. dynamic range: 90dB(below 2GHz), 75dB(4.4GHz)(25 times average 100Hz IF are turned on), if 100Hz 25 times average are turned on, 100db of dynamics can be achieved below .3GHz.
5.S11 dynamic range: better than 50db
.2 port return loss: 30dB typ(.5GHz), 20dB min(4.4GHz)
7. Interface: Communication Mode: (Serial)
8. Number of calibration points: 101-1001 points
9. Number of scanning points: 101-1001 points
10. Display trace: 7 traces
11. Mark: 8 mark points(the mark bar can be moved anywhere on the screen)
12. Save settings: 12(quick menu)(after saving, it can be directly called when the next startup is used, no need to re-calibrate, the saved parameters before the last shutdown will be automatically recalled when the next startup, the function of automatically storing the start end frequencies is added., which is convenient for the next call) Built-in file saving, in principle, unlimited storage units can be saved, depending on the capacity of the TF card.
13. Scanning speed: about 400 points/second
14. It can measure S parameters, voltage standing wave ratio, SWR, for chart, phase diagram, group delay, TDR function...;
15. Using a 7-inch high-brightness IPS capacitive touch screen, the viewing angle of IPS TFT(1024x600) is close to 180°, it will not hurt the eyes when used for a long time; payment)
16. The metal case is used to effectively shield electromagnetic interference, making better than 100dB dynamic range within 2GHz
17. Compact design, body size 195mm*150mm*35mm, small portable; outer packaging size: 25x20x7cm
18. The radio frequency interface is L16-F(N female base), which is convenient to connect various DUTs;
19. The standard configuration uses two batteries with a total capacity of 6600mAh, the battery life can reach 4 hours;(you can modify it to install two 21700 battery holders, the capacity can reach 10000mAH, the battery life can reach about hours.
20. Full touch screen design, supports 4 front panel buttons at the same time, flexible convenient operation;
21. Support Chinese menu;
22. Support screen brightness adjustment;
23. Upgrade the firmware through a virtual for U disk, no programmer is needed, only a cable can be used to upgrade the firmware;
22. Expand a output interface, 5V/1A output(can be used as a bank);
24. Using high current 2A charging IC, the charging time is shorter;
25. Support the host computer, you can use the computer as the display operation interface;
26. Net weight: 1160 grams,
27. Total weight of outer packaging: 1590 grams.
28. Support screenshots upload screenshots to the computer.
Specification:
- Frequency range: 50KHz-4.4GHz
- RF output :-42dBm to-12dBm(1dB step)
- RF interface form: N-type female connector(with N to for SMA adapter)
- RF input : maximum 0dBm(DC<5V)
- Frequency Accuracy:<±1ppm(<140MHz)<±5KHz(>140MHz)
- dynamic range: 75dB(<3GHz); 60dB(>3GHz)
- S11 dynamic range: 50dB(<3GHz); 40dB(>3GHz)
- Scan point: 1001(can be set to 101-1001)
- Scanning speed: 400 points/sec(f>140MHz)
- IF bandwidth: 12.5KHz by default(optional.25k/3.12k/1k/300Hz/100Hz/30Hz)
- Smoothing: arithmetic mean(average factor: -25 times)
- Number of traces: 7(4 measurement traces, 2 reference traces, TDR trace)
- Number of markers: 8
- Calibration state storage number: 12 groups(support file storage to internal memory card)
- Storage capacity: Built-in 8GB memory card
- Display: 7 inch high brightness IPS LCD display(resolution: 1024x600)
- Operation Mode: Capacitive Touch+ Physical Button
- Local screenshot: support
- consumption: 5W
- Battery life: 4 hours(50% screen brightness)
- Battery: built-in 2 X lithium batteries(3.6V/3350mAh x 2)
- Charging/Data Interface:
- Charging voltage: 4.7V-5.5V(5V/2A charging recommended)
- output: 5V/1A
- Shell Material: Iron
- Working temperature: 0℃- 45℃
- Dimensions: 190x130x30mm/7.48x5.12x1.18in(without RF interface size)
Grade:
Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
Please allow -2cm measuring deviation due to manual measurement.
Packing list:
x SV4401A
2 x N to for SMA adapters
x for SMA Open/Short/Load Calibration Kit
2 x for SMA double female direct headers
x for SMA double male straight connector
2 x 50cm/19.7" RG316 cables
x cable
x storage bag