Cart 2 india

Specification
AutomotiveFitType : vehicle_specific_fit
AutoPartPosition : rear
Brand : ECOTRIC
BulletPoint1 : FEATURE: Made of High Quality ABS Plastic Material. Color: Gloss Black. Surface Finish: Painted. Style: MU Style. Placement on Vehicle: Rear
BulletPoint2 : FITMENT: Compatible with 2006 2007 2008 2009 2010 2011 Honda Civic 4 Door Sedan Trunk. Direct replacements for damaged rear trunk spoiler wing
BulletPoint3 : PACKAGE INCLUDING: 1 x Rear Trunk Spoiler Wing ( ALL HARDWARE INCLUDED. As the picture shown)
BulletPoint4 : INCREASE AERODYNAMIC PERFORMANCE: Effectively reduce and overcome the influence of air resistance when the car is driving at high speed. The wind resistance coefficient is reduced, so that the car can drive close to the road surface, thereby improving the stability of driving
BulletPoint5 : INSTALLATION: Easy installation. Drilling may be required. Instructions NOT included
Color : Gloss Black
CompatibleWithVehicleType : Car
ExteriorFinish : Gloss Black
ExternallyAssignedProductIdentifier : 06974718204453
ExternallyAssignedProductIdentifier1 : 765477222477
ExternallyAssignedProductIdentifier2 : 0765477222477
GpsrSafetyAttestation : 1
IncludedComponents : 1 x trunk spoiler, mounting hardware & tape
IncludedComponents1 : 1*GT Wing Spoiler
IncludedComponents2 : 1* Maual
InstallationType : Peel & Stick
IsAssemblyRequired : 1
ItemName : ECOTRIC Rear Trunk Spoiler Wing Compatible with 2006-2011 Honda Civic 4 Door Sedan ABS Trunk Spoiler Wing Painted Gloss Black
ItemPackageDimensions_Height : 111.76 centimeters
ItemPackageDimensions_Length : 21.59 centimeters
ItemPackageDimensions_Width : 29.21 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : automotive-spoilers-and-wings
Manufacturer : ECOTRIC
Material : Acrylonitrile Butadiene Styrene (ABS)
ModelName : VC-LYAP-530
ModelNumber : VC-LYAP-530
NumberOfBoxes : 1
NumberOfItems : 1
PackageLevel : unit
PartNumber : ET-713
ProductDescription : INSTALL：1. Clean The Pre-installed Position, Make Sure The Position Is Clean And Dry Before You Install. 2. Measure The Length Of The Tail In Need. 3. Cut Off Excess Length. 4. Use The Adhesion Promoter(wipe Paper) To Wipe The Pre-installed Position, Then Wait About 10 Seconds. 5. Tear The Back Of The Glue Which On The Auto Device Rubber Strip. 6. Put On The 2-end Sleeve And Stick It Slowly With Strength. The Sleeve Can Be Perfectly Closed And Make Your Car Looks Great
Size : 1.3in Width, 4.9ft Length
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 25170000
WarrantyDescription : No Warranty