Cart 2 india

Specification
Brand : TGB
BulletPoint1 : A low-hydrogen, all-position electrode for welding carbon steel, high-tensile steel, low alloy steel and free-machining steels - AWS/SFA 5.1 E7018 - AC/DC+ (Reverse Polarity)
BulletPoint2 : Quiet steady arc, low spatter, superb re-striking capabilities and high deposition efficiency all made possible by the special low-hydrogen iron powder coating and graphite tip
BulletPoint3 : Easily removable slag reveals a finely rippled bead appearance and an x-ray quality weld deposit with excellent charpy impact values at sub-zero temperatures (78 ft-lbs at -20°F)
BulletPoint4 : Typical applications include structural and fabrication steels such as I-beams, angles, plates, channels, cast steels, cold rolled steel, process piping steels and shipbuilding steels
BulletPoint5 : Select your Electrode Diameter and Package Quantity from the Options - Check Picture #3 for Welding Parameters.
Capacity : 10 pounds
Color : Small Plug
ControlType : Knob
CustomerPackageType : Standard Packaging
ExternallyAssignedProductIdentifier : 7638140662630
ExternallyAssignedProductIdentifier1 : 0600136287803
ExternallyAssignedProductIdentifier2 : 600136287803
FinishType : Painted
IncludedComponents : Comb Tube
ItemDisplayDimensions_Length : 314.96 centimeters
ItemDisplayWeight : 56.9 pounds
ItemForm : Rod
ItemName : E7018 - Low Hydrogen/High Tensile - Welding Electrode/Rod - 16" x 5/32" (PACK: 55 LB)
ItemPackageDimensions_Height : 61.214 centimeters
ItemPackageDimensions_Length : 17.018 centimeters
ItemPackageDimensions_Width : 20.828 centimeters
ItemPackageQuantity : 1
ItemShape : Cylindrical
ItemTypeKeyword : arc-welding-stick-electrodes
Manufacturer : TGB
Material : Steel
ModelName : Masyrt3rfkbgc12z
ModelNumber : Masyrt3rfkbgc12z
NumberOfItems : 1
NumberOfLithiumMetalCells : 1
PackageLevel : unit
PartNumber : 7018E16x532x55
ProductDescription : Instructions: Use this electrode with DC+ (reverse polarity), however, an AC machine with sufficient open circuit voltage may be used. Clean the weld zone of all contaminants. Bevel thick sections to a 60° Vee and preheat at 300-500°F. Set amperage to the proper range as listed on the product recommended amperage chart. Maintain a short arc length and hold the electrode at a 15° angle into the direction of travel. Weaving technique is preferred, however, do not exceed 3 times the diameter of the electrode. Do not use the whipping technique as this will cause porosity in the weld deposit. Always allow high-carbon steels to cool slowly before removing the slag.
ProductSiteLaunchDate : 2018-05-07T20:52:10.559Z
Size : 5/32" (55 Lb)
Style : Modern
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 23271800