Cart 2 india

Specification
Brand : WL Fuller
BulletPoint1 : 1/8" Drill Diameter for #5 Wood Screws
BulletPoint2 : Replacement Bit for TPS-Lock Shank System
BulletPoint3 : Use with QST08 TPS-Lock Shank
BulletPoint4 : Recommended for most jobs, whether in a drill press or in hand held equipment
BulletPoint5 : Cuts very well in both hard and soft woods
FinishType : Uncoated
GpsrSafetyAttestation : 1
ItemName : W.L. Fuller 20130125 1/8" HSS Taper Point Replacement Drill Bit for TPS-Lock Shank System
ItemPackageDimensions_Height : 11.6 centimeters
ItemPackageDimensions_Length : 0.6 centimeters
ItemPackageDimensions_Width : 5.8 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : taper-point-drill-bits
Manufacturer : W.L. Fuller
Material : High Speed Steel
ModelNumber : 20130125
NumberOfFlutes : 2
NumberOfItems : 1
PartNumber : 20130125C
ProductDescription : TPS-Lock Shank System General Purpose Taper Point Replacement Drill Bits - Recommended for most jobs, whether in a drill press or in hand held equipment. Cuts very well in both hard and soft woods. To cut wood and plastics in one operation for the thread and shank of wood screws. Taper Point Drills are made of High Speed Steel to hold their sharp cutting edges longer. How to engage the TPS-Lock grip: Align the flat provided on the shank of the new replacement drill with the set screw hole. Use a small hammer to tap the shank onto the replacement drill. Replace and tighten the set screw. How to release the TPS-Lock grip: Loosen and remove the single hex socket set screw. Tap on the shank to drive it off the drill.
ProductSiteLaunchDate : 2013-09-28T05:10:41.582Z
Size : 1.6mm
SupplierDeclaredDgHzRegulation : not_applicable
SurfaceRecommendation : Wood
UnitCount : 1
UnspscCode : 27111700