Cart 2 india

Specification
Brand : WL Fuller
BulletPoint1 : 11/64" Drill Diameter for #8 Wood Screws
BulletPoint2 : Replacement Bit for TPS-Lock Shank System
BulletPoint3 : Use with QST11 TPS-Lock Shank
BulletPoint4 : Recommended for most jobs, whether in a drill press or in hand held equipment
BulletPoint5 : Cuts very well in both hard and soft woods
ItemName : W.L. Fuller 20130171 11/64" HSS Taper Point Replacement Drill Bit for TPS-Lock Shank System
ItemPackageDimensions_Height : 0.59 inches
ItemPackageDimensions_Length : 5.51 inches
ItemPackageDimensions_Width : 3.94 inches
ItemPackageQuantity : 1
ItemTypeKeyword : taper-point-drill-bits
Manufacturer : W.L. Fuller
Material : High Speed Steel
ModelNumber : 20130171
NumberOfFlutes : 2
NumberOfItems : 1
PartNumber : 20130171C
ProductDescription : TPS-Lock Shank System General Purpose Taper Point Replacement Drill Bits - Recommended for most jobs, whether in a drill press or in hand held equipment. Cuts very well in both hard and soft woods. To cut wood and plastics in one operation for the thread and shank of wood screws. Taper Point Drills are made of High Speed Steel to hold their sharp cutting edges longer. How to engage the TPS-Lock grip: Align the flat provided on the shank of the new replacement drill with the set screw hole. Use a small hammer to tap the shank onto the replacement drill. Replace and tighten the set screw. How to release the TPS-Lock grip: Loosen and remove the single hex socket set screw. Tap on the shank to drive it off the drill.
ProductSiteLaunchDate : 2013-09-28T05:10:43.764Z
Size : 1.6mm
SupplierDeclaredDgHzRegulation : unknown
SurfaceRecommendation : Wood
UnitCount : 1
UnspscCode : 27110000