Cart 2 india

Specification
Brand : TIMKEN
BulletPoint : Roller Bearings
BulletPoint1 : Cone (inner ring assembly) and cup (outer ring) combine to form a complete single tapered roller bearing
BulletPoint2 : Supports both radial and axial loads between a rotating and non-rotating member
BulletPoint3 : Operating temperatures range from -54 to 120 degrees C (-65 to 250 degrees F)
BulletPoint4 : Stamped steel cage evenly spaces rollers for reduced friction, vibration, and noise
BulletPoint5 : Open configuration for lubrication applied in place
Color : One Color
ExternallyAssignedProductIdentifier : 8047297882737
ExternallyAssignedProductIdentifier1 : 0023688736399
ExternallyAssignedProductIdentifier2 : 023688736399
IncludedComponents : NSK Japan NU204W C3 Cylindrical Roller Bearing 20x47x14 mm
ItemName : Timken SET3 Tapered Roller Bearing Cone and Cup Set, Steel, Inch, 0.8437" ID, 1.9690" OD, 0.690" Cup Width
ItemPackageDimensions_Height : 2.54 centimeters
ItemPackageDimensions_Length : 5.842 centimeters
ItemPackageDimensions_Width : 6.096 centimeters
ItemPackageQuantity : 1
ItemShape : Cup and Cone
ItemTypeKeyword : tapered-roller-bearings
Manufacturer : Timken
Material : Steel
ModelNumber : TIM-SET3
NumberOfItems : 1
PartNumber : SET3
ProductDescription : Roller Bearings
Bearing
DRAWN CUP NEEDLE ROLLER BEARINGS
The outer ring of drawn cup needle roller bearing is punched with the high-quality steel sheet. The outer ring has thin wall.
The drawn cup needle roller bearing has the characteristics of small radial section area, large load carrying capacity, less inertia and economic manufacture. It is suitable for small section height, or when the housing bore isn't used for raceway, this type is recommended to use. The bearing is assembled into the housing bore under a certain pressure without further axial location.
The drawn cup needle roller bearing generally takes its shaft diameter as the internal raceway. However, the proper LR type inner ring can be used in accordance with application condition.
The drawn cup needle roller bearing has two structures-with retainer and with full of needles. They are divided into opened type and close-end type. The structure with retainer has the single seal ring and double seal ring. The structure with full of needles has a large load carrying capacity.
Characteristics & classification
The outer ring of drawn cup needle roller bearing is punched with the steel sheet It has the small sectional height and the large load carrying capacity and is suitable for economic mass production
The interference fit between outer ring and bearing housing is applied to this kind of needle roller bearing without axial fixing device Even for the condition of high load it fully maintains bearing function either. In addition, with the large greasestorage capacity, it is unnecessary to add grease for a long-term operation.
Since one end of the close-end bearing is sealed, it is suitable for the end of shaft with bearing the small axial sliding force.
Model HK, TA, TLA, open-end drawn cup needle roller bearings with retainer,
Model BK close-end drawn cup needle roller bearing with retainer,
Model SCE, BA, J, JH, drawn cup needle roll
ProductSiteLaunchDate : 2012-01-23T00:00:01-08:00
Size : One Size
SpecificationMet : Abec
Style : Tapered
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1
UnspscCode : 31171500