Home / Industrial & Scientific / Test Leads

Hantek Oscilloscope Accessory Set 20:1 Attenuator with Auto Test Leads and Acupuncture Probe for Automobile Measurement(201 * 2+30A+307)

Hantek Oscilloscope Accessory Set 20:1 Attenuator with Auto Test Leads and Acupuncture Probe for Automobile Measurement(201 * 2+30A+307)

Imported from USA | Ships in 10 working days

5% instant discount on non COD

1

₹ 9500/-

The price at cart2india.com is inclusive of custom duties, GST, freight forwarding and other charges.

Proceed to Pay

Free Shipping across India. Powered by BlueDart

Product Information


Specification
Brand : Hantek
BulletPoint1 : HT30A: A special line for assisting automobile measurement instruments to test various types of signals. It consists of wide range probes, clips, gators can be plugged into the 4 mm connectors at the end of the cable
BulletPoint2 : HT30A: 3M BNC to banana adapter cable, heavy duty auto test lead. Allowing the oscilloscope away form the car being tested or repaired and placed on the bench
BulletPoint3 : HT30A: To avoid the lines twisting together, the 2 connectors has different length. The short line is earth wire, and the long line is positive pole which should be connected with the auto engine cable
BulletPoint4 : HT201: HT201 Attenuator designed for assisting automobile measurement. Passive attenuator with 20:1 attenuation, if input a 20V signal, it can output a 1V signal. Bandwidth: 10MHz
BulletPoint5 : HT201: The HT201 has been designed to allow fuel injector and primary ignition waveforms to be measured using Hantek oscilloscope products. Please note this attenuator should not be used for any high voltage measurements other than fuel injectors and primary ignition
BulletPoint6 : HT307: This probe set is a back pinning, piercing and repairable probe. It is essential for probing today’s small, fragile connector
BulletPoint7 : HT307: Using for piercing the insulation of wires to allow for automotive electrical measurements without causing damage to the wires. Additionally they can be used as pin-tip probes while working with small circuit boards
ItemName : Hantek Oscilloscope Accessory Set 20:1 Attenuator with Auto Test Leads and Acupuncture Probe for Automobile Measurement(201 * 2+30A+307)
ItemPackageDimensions_Height : 22.098 centimeters
ItemPackageDimensions_Length : 2.3876 centimeters
ItemPackageDimensions_Width : 15.7988 centimeters
ItemTypeKeyword : test-leads
Manufacturer : Hantek
NumberOfItems : 1
PartNumber : HT201*2+HT30A+HT307
ProductSiteLaunchDate : 2025-05-07T07:00:00.000Z
Style : HT30A+201*2+307
SupplierDeclaredDgHzRegulation : not_applicable
UnspscCode : 41113700

Questions & Answers

Have a question? Ask experts

?
No question found

Ratings & Review

Rating Breakdown (average)

5*
0
4*
0
3*
0
2*
0
1*
0

No reviews found.

Have an opinion on this page? Let's hear it.