Cart 2 india

Specification
Brand : Aumzong
BulletPoint1 : Function: valve spring tool used to disassemble the spring and install the spring
BulletPoint2 : Compatible with LS Engine Firebird, Silverado, Camaro, GTO, Trans am, Corvette, CTSV, Sierra, Tahoe, Suburban, Pontiac G8 GT and more.Not for small block chevy engines
BulletPoint3 : Valve spring compression tool for 4.8 5.3 5.7 6.0 and 6.2L LS engines，LS1 LS2 LS3 LS6 Series
BulletPoint4 : Valve spring compression tool Replaces OE 67605
BulletPoint5 : 6 months warranty, factory inspected 100%, meets or exceeds original OE.Installation can be done by watching Youtube videos
CustomerPackageType : Standard Packaging
ExternallyAssignedProductIdentifier : 8011588507876
FitType : Vehicle Specific
ItemName : Aumzong Valve Spring Compressor tool, LS series valve spring removal tool kit,Compatible with Chevy GM Trucks 4.8 5.3 5.7 6.0 6.2 LS1 LS2 LS3 LS6 Engine,Chevy LSX Camaro, Corvette, Trans am, GTO, G8
ItemPackageDimensions_Height : 15.0114 centimeters
ItemPackageDimensions_Length : 4.3942 centimeters
ItemPackageDimensions_Width : 10.795 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : automotive-valve-train-tools
Manufacturer : Aumzong
NumberOfBoxes : 1
PartNumber : BL-67605
ProductDescription :

Installation steps：

First remove the valve cover, remove the rocker arm and rocker arm guide

Next place the bottom aluminum plate where the rocker arm bolts are mounted and the middle section on top of the one with the studs and mount it on the head with 2 bolts, making sure the tool is set between the two valve springs. Hand tighten with a wrench and socket. Do not over tighten, if you use impact it will cause damage to the head.

Place the top on the two valve springs and install the nuts. As shown in the scene diagram. Note: Always make sure the studs are greased.

If you are using the head on an engine mounted head, then you will want to use a fitting of compressed air in the spark plug hole to keep the valve pushed close before tightening.

Do not use impact as this will cause the nut to overheat and strip the threads! , only tighten the nut manually and slowly.

To keep them from falling into the head, after compressing the spring, you can use a magnet to remove the valve retainer

After removing the retainer, you need to slowly reverse the nut to release the pressure and remove the spring.

Install the new spring using the same procedure. Hold it in place properly before releasing the pressure and make sure it is in place when you reinstall the valve retainer

ProductSiteLaunchDate : 2021-10-09T07:16:01.951Z
Size : LS Valve Spring Compressor tool
SupplierDeclaredDgHzRegulation : other
UnspscCode : 40141600