Cart 2 india

Specification
Brand : Ozark Fence
BulletPoint1 : ZINC ​PLATED: Helps ​prevent ​rust ​in ​dry ​environments; dependable ​application ​and ​maintenance
BulletPoint2 : WIDE ​RANGE ​OF ​SIZES: Ensures ​correct ​fastener ​for ​effective ​results
BulletPoint3 : FOR ​USE ​IN ​CONCRETE ​ONLY: Provides ​most ​consistent ​holding ​values; ​secure application
BulletPoint4 : PACKAGED ​WITH​ ​NUTS ​AND ​WASHER: Fast, ​quick, ​complete ​installation
BulletPoint5 : HOLE ​SIZE ​IS ​ANCHOR ​SIZE: Quick ​and ​easy ​installation; ​simple ​to ​order
BulletPoint6 : Tested per ACI355.2 and AC193
BulletPoint7 : This product image may represent a range of products; it may not be an exact representation of the product purchased.
Color : Zinc Plating
ExteriorFinish : Stainless Steel
ExternallyAssignedProductIdentifier1 : 0850062203570
ExternallyAssignedProductIdentifier2 : 850062203570
FinishType : Zinc
ItemName : 1/2" x 3-3/4" Wedge Anchor Zinc Plated (200)
ItemPackageQuantity : 1
ItemTypeKeyword : wedge-anchors
Manufacturer : Ozark Fence
ManufacturerGrade : Grade 2
Material : Steel
NumberOfItems : 200
PartNumber : 03061
ProductDescription : Drill a 1/2" hole into the concrete using a carbide-tipped bit that meets ANSI Standards B212.15. Drill the hole a 1/2" deeper than the anchor will penetrate the concrete, making sure the minimum embedment requirements of 2-1/4" is met. The hole can be drilled while the fixture is in place. The minimum hole in the fixture for the 1/2" x 3-3/4" Wedge Anchor Zinc Plated is 5/8". Clean the hole with a wire brush, vacuum, compressed air, or a blow-out bulb. Put the nut and washer on the 1/2" x 3-3/4" Wedge Anchor Zinc Plated, making sure the nut is on the last threads; this will protect the threads from damage when the wedge anchor is hammered into the hole and into the concrete. Insert the anchor through the hole in the fixture and into the hole in the base material. This should be a very tight fit. Then use a hammer to complete the installation until the nut and washer are tight against the fixture. It is important that the threads go below the surface of either the base material or the fixture. Turn the nut clockwise on the anchor until finger tight. Using a 3/4" wrench, turn the nut 3 to 4 times until snug or until the proper torque value of 50 - 60 ft./lbs. is reached. Always use proper personal protective equipment per manufacturer's and OSHA instructions.
ProductSiteLaunchDate : 2024-05-01T18:11:33.712Z
Size : 1/2" x 3-3/4"
SupplierDeclaredDgHzRegulation : not_applicable
UnspscCode : 31160000