Cart 2 india

Specification
Brand : CONFAST
BulletPoint : 10 Pcs Carriage bolt round head square neck carriage bolt full thread 3/8-16X1-3/4 full thread no mark 2136
BulletPoint1 : ZINC PLATED - Helps prevent rust in dry environments
BulletPoint2 : WIDE RANGE OF SIZES - Insures proper fastener for best results
BulletPoint3 : PACKAGED WITH NUTS AND WASHERS - Fast, quick, complete installation
BulletPoint4 : HOLE SIZE IS ANCHOR SIZE - Simplicity and ease of installation
BulletPoint5 : [Complete Fastening Kit for Convenience]: This complete fastening kit includes 8 pieces of 5/16-18x5/8 inch carriage bolts, 8 hex nuts, and 8flat washers, providing everything you need for a hassle-free installation. With precise threading, smooth surfaces, and corrosion-resistant stainless steel construction, this set ensures an efficient and reliable fastening solution for various construction and repair projects.
Color : Silver
ExteriorFinish : Zinc
FinishType : Plain
ItemName : CONFAST American Made 1/2" x 8-1/2" Zinc Plated Wedge Anchor (25 per Box)
ItemPackageDimensions_Height : 3.5 inches
ItemPackageDimensions_Length : 12.5 inches
ItemPackageDimensions_Width : 4.5 inches
ItemPackageQuantity : 1
ItemShape : Block,wedge
ItemTypeKeyword : wedge-anchors
Manufacturer : CONFAST
Material : Carbon Steel Zinc Plated
MaximumShearStrength : 7419
ModelNumber : QAQCB5C
NumberOfItems : 25
NumberOfPieces : 25
PartNumber : TS12812
ProductDescription : Applications
The anchor is made from Carbon Steel, and is Zinc Plated and meets the Buy America Act (BAA). This anchor is designed for use in Concrete only, and should never be used in block or brick base material.

Environment
The anchor is designed for use in a Dry environment.

Hole Diameter/Bit Diameter
The anchor requires a 1/2" hole to be drilled in the base material (Concrete only). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Diameter of Anchor
The diameter of the anchor is 1/2".

Length Anchor
The length of the anchor is 8-1/2"

Thread Length
The length of the threads on the anchor is 1-1/2" in length.

Minimum Embedment
The minimum anchor embedment into the concrete is 2-1/4". Therefore, the anchor must be installed so that a minimum of 2-1/4" of the anchor is embedded into the concrete.

Maximum Fixture Thickness
The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 5-1/2". This will ensure that the minimum embedment of 2-1/4" will be met.

Fixture Hole Diameter
The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 1/2" diameter anchor requires the hole in the fixture to be 5/8".

Spacing between Anchors
Each anchor must be spaced a minimum distance of 5" from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 2.5" from an unsupported edge of the concrete.
ProductSiteLaunchDate : 2017-06-13T11:52:38.534Z
Size : One Size
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 31160000