Cart 2 india

Specification
Brand : YWNYT
BulletPoint1 : Maximum working pressure of 2000 psi, temperature range from -100 to +660 degrees ℉.
BulletPoint2 : The concrete anchor is for heavy duty fastening applications where high pull out values in concrete are needed. It is for concrete only, not for block or brick base material.
BulletPoint3 : Material: Made from 304 Stainless Steel, can be used in wet, submerged environments and will not rust.
BulletPoint4 : Hole Size Is Anchor Size: Drill bit diameter/Hole diameter is the same as anchor diameter. Use a 3/8" drill bit to drill a hole in the base material (Concrete only).
BulletPoint5 : The wedge anchor is used in fastening sheet metal, steel and aluminum angles, or wood to concrete.
BulletPoint6 : Support available - every Dorman part is backed by Dorman's ASE Blue Seal Certified technical support team
Color : Silver
ExteriorFinish : Zinc
ExternallyAssignedProductIdentifier1 : 0784497229327
ExternallyAssignedProductIdentifier2 : 784497229327
FinishType : Zinc
GradeRating : Grade C
ItemName : Red Head WS-1244 Trubolt Carbon Steel Wedge 1/2-Inch by 4-1/2-Inch Anchor (25 per Box) by ITW Red Head
ItemPackageDimensions_Height : 1.57 inches
ItemPackageDimensions_Length : 5.12 inches
ItemPackageDimensions_Width : 3.15 inches
ItemPackageQuantity : 1
ItemShape : Round
ItemTypeKeyword : wedge-anchors
Manufacturer : Red Head
ManufacturerGrade : Grade 2
Material : Carbon Steel
MetalType : Stainless Steel
ModelNumber : 45658
NumberOfItems : 1
NumberOfPieces : 26
PartNumber : WS1244:2
ProductDescription :

Applications
The anchor is made from Carbon Steel, and is Zinc Plated. This anchor is designed for use in Concrete only, and should never be used in block or brick base material.

Hole Diameter/Bit Diameter
The anchor requires a 1/2" hole to be drilled in the base material (Concrete only). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Thread Length
The length of the anchor is 4-1/2"

Minimum Embedment
The minimum anchor embedment into the concrete is 2-1/4". Therefore, the anchor must be installed so that a minimum of 2-1/4" of the anchor is embedded into the concrete.

Wrench Size
The size of the wrench required to turn the nut to set the anchor is 3/4".

Torque Value
The maximum torque that can be applied to the anchor once installed is 55 ft./lbs.

Spacing between Anchors
Each anchor must be spaced a minimum distance of 7-7/8" from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 3-15/16" from an unsupported edge of the concrete.

Holding Values - Ultimate Load Values in 2000 PSI Concrete
Minimum Embedment 2-1/4" Pull-Out (lbs.) 3455 Shear (lbs.) 4760
ProductSiteLaunchDate : 2016-04-29T19:09:26.944Z
Size : 3/8" x 2 1/4"
SupplierDeclaredDgHzRegulation : unknown
UnitCount : 6
UnspscCode : 31161500