Cart 2 india

Specification
Brand : Generic
BulletPoint1 : 【 Baud rate 】Communication baud rate 9600.N.8.1
BulletPoint2 : 【 Communication format 】Wiegand 26~37, RS232, RS485, TTL frequency and other communication specifications meet your needs
BulletPoint3 : 【 Two sizes 】86 × 86mm, 102 × 48mm, two sizes available for selection
BulletPoint4 : 【 Waterproof design 】With an outdoor protection rating of IP68, you can rest assured that this reader will withstand all outdoor conditions.
BulletPoint5 : 【 Wiegand format 】Wiegand26-37 adaptive format output
Color : Black
ExternallyAssignedProductIdentifier1 : 0763871223816
ExternallyAssignedProductIdentifier2 : 763871223816
IncludedComponents : Reader
ItemName : 125Khz HID RF Card Reader, Waterproof Design, Suitable for Access Control Systems, Wiegand, RS232, RS485, UART TTL formats (102 × 48, Wiegand 26~37)
ItemPackageDimensions_Height : 1.69 inches
ItemPackageDimensions_Length : 5.31 inches
ItemPackageDimensions_Width : 2.87 inches
ItemTypeKeyword : commercial-access-wiegand-card-readers
Manufacturer : HEYGLI
ModelNumber : 102 × 48
NumberOfItems : 2000
PartNumber : HGL-015
ProductDescription : Product parameters
Product name : HID Rfid Card Reader
Operating Frequency : 125Khz
Sensing distance : 0-15CM
Operating voltage : DC 9V-16V
Support cards : HID Card
Communication format : RS485, RS232, TTL frequency, Wiegand 26-37
Operating temperature : -30℃-85℃
Ways of identifying : Swipe card
Transmission distance : RS232 (10 meters), RS485(1200 meters), WG(100 meters)
Shell material : Using PVC, ABS fire retardant material, Internal adhesive waterproofing
Installation precautions
1.The line from the card reader to the controller: It is recommended to use an 8-core shielded multi-strand twisted pair network cable (two of which are spare, if the card reader light feedback legal card is not required, the LED cable can not be connected, if the buzzer of the card reader is not used) The Buzzer line can not be connected to the illegal card feedback from the device), and the data lines Data1 and Data0 are a pair of twisted pairs. The wire diameter is recommended to be more than 0.3 square millimeters. The longest can not exceed 100 meters. The shield wire is connected to the GND of the controller.
2. The card reader is installed on a metal surface. Since the card reader is a radio frequency product, the metal pair near the front or the rear will absorb its radio frequency signal. If the metal surface is large, it will even affect the card reader. card, or the reading distance is very attenuated.
3. The distance between the two card readers will also affect the card reader, some will shorten the card reading distance, and some will cause the two card readers to read the card at the same time or the card reader cannot read the card.
Solution: Try not to install it on a metal plane, or dig out the metal part with the back of the card reader installed, and keep the distance between the two card readers more than 25cm
ProductSiteLaunchDate : 2023-09-01T13:38:29.037Z
Size : 102 × 48
Style : Wiegand 26~37
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnspscCode : 31160000